| # |
| # Asix network device configuration |
| # |
| |
| config NET_VENDOR_ASIX |
| bool "Asix devices" |
| default y |
| help |
| If you have a network (Ethernet, non-USB, not NE2000 compatible) |
| interface based on a chip from ASIX, say Y. |
| |
| if NET_VENDOR_ASIX |
| |
| config SPI_AX88796C |
| tristate "Asix AX88796C-SPI support" |
| select PHYLIB |
| depends on SPI |
| depends on GPIOLIB |
| help |
| Say Y here if you intend to use ASIX AX88796C attached in SPI mode. |
| |
| config SPI_AX88796C_COMPRESSION |
| bool "SPI transfer compression" |
| default n |
| depends on SPI_AX88796C |
| help |
| Say Y here to enable SPI transfer compression. It saves up |
| to 24 dummy cycles during each transfer which may noticeably |
| speed up short transfers. This sets the default value that is |
| inherited by network interfaces during probe. It can be |
| changed at run time via spi-compression ethtool tunable. |
| |
| If unsure say N. |
| |
| endif # NET_VENDOR_ASIX |
