| # SPDX-License-Identifier: GPL-2.0-only |
| # |
| # Solarflare device configuration |
| # |
| |
| config NET_VENDOR_SOLARFLARE |
| bool "Solarflare devices" |
| default y |
| help |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Solarflare devices. If you say Y, you will be asked |
| for your specific card in the following questions. |
| |
| if NET_VENDOR_SOLARFLARE |
| |
| config SFC |
| tristate "Solarflare SFC9000/SFC9100/EF100-family support" |
| depends on PCI |
| depends on PTP_1588_CLOCK_OPTIONAL |
| select MDIO |
| select CRC32 |
| help |
| This driver supports 10/40-gigabit Ethernet cards based on |
| the Solarflare SFC9000-family and SFC9100-family controllers. |
| |
| It also supports 10/25/40/100-gigabit Ethernet cards based |
| on the Solarflare EF100 networking IP in Xilinx FPGAs. |
| |
| To compile this driver as a module, choose M here. The module |
| will be called sfc. |
| config SFC_MTD |
| bool "Solarflare SFC9000/SFC9100-family MTD support" |
| depends on SFC && MTD && !(SFC=y && MTD=m) |
| default y |
| help |
| This exposes the on-board flash and/or EEPROM as MTD devices |
| (e.g. /dev/mtd1). This is required to update the firmware or |
| the boot configuration under Linux. |
| config SFC_MCDI_MON |
| bool "Solarflare SFC9000/SFC9100-family hwmon support" |
| depends on SFC && HWMON && !(SFC=y && HWMON=m) |
| default y |
| help |
| This exposes the on-board firmware-managed sensors as a |
| hardware monitor device. |
| config SFC_SRIOV |
| bool "Solarflare SFC9000-family SR-IOV support" |
| depends on SFC && PCI_IOV |
| default y |
| help |
| This enables support for the SFC9000 I/O Virtualization |
| features, allowing accelerated network performance in |
| virtualized environments. |
| config SFC_MCDI_LOGGING |
| bool "Solarflare SFC9000/SFC9100-family MCDI logging support" |
| depends on SFC |
| default y |
| help |
| This enables support for tracing of MCDI (Management-Controller-to- |
| Driver-Interface) commands and responses, allowing debugging of |
| driver/firmware interaction. The tracing is actually enabled by |
| a sysfs file 'mcdi_logging' under the PCI device. |
| |
| source "drivers/net/ethernet/sfc/falcon/Kconfig" |
| |
| endif # NET_VENDOR_SOLARFLARE |
