agp: intel-agp: do not use PCI resources before pci_enable_device()
IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.
The semantic match that finds this problem is as follows:
// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@
(
* x->irq
|
* x->resource
|
* request(x, ...)
)
...
*pci_enable_device(x)
// </smpl>
Signed-off-by: Kulikov Vasiliy <segooon@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
diff --git a/drivers/char/agp/intel-agp.c b/drivers/char/agp/intel-agp.c
index 5bbc7be..ddf5def 100644
--- a/drivers/char/agp/intel-agp.c
+++ b/drivers/char/agp/intel-agp.c
@@ -908,6 +908,17 @@
dev_info(&pdev->dev, "Intel %s Chipset\n", intel_agp_chipsets[i].name);
/*
+ * If the device has not been properly setup, the following will catch
+ * the problem and should stop the system from crashing.
+ * 20030610 - hamish@zot.org
+ */
+ if (pci_enable_device(pdev)) {
+ dev_err(&pdev->dev, "can't enable PCI device\n");
+ agp_put_bridge(bridge);
+ return -ENODEV;
+ }
+
+ /*
* The following fixes the case where the BIOS has "forgotten" to
* provide an address range for the GART.
* 20030610 - hamish@zot.org
@@ -921,17 +932,6 @@
}
}
- /*
- * If the device has not been properly setup, the following will catch
- * the problem and should stop the system from crashing.
- * 20030610 - hamish@zot.org
- */
- if (pci_enable_device(pdev)) {
- dev_err(&pdev->dev, "can't enable PCI device\n");
- agp_put_bridge(bridge);
- return -ENODEV;
- }
-
/* Fill in the mode register */
if (cap_ptr) {
pci_read_config_dword(pdev,
