Merge tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl
Pull pin-control fixes from Linus Walleij:
"This kernel cycle has been calm for both pin control and GPIO so far
but here are three pin control patches for you anyway, only really
dealing with Baytrail:
- Two fixes for the Baytrail driver affecting IRQs and output state
in sysfs
- Use the linux-gpio mailing list also for pinctrl patches"
* tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl:
pinctrl: baytrail: show output gpio state correctly on Intel Baytrail
pinctrl: use linux-gpio mailing list
pinctrl: baytrail: Clear DIRECT_IRQ bit
diff --git a/MAINTAINERS b/MAINTAINERS
index f155c2a..5d6136b8 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -7180,6 +7180,7 @@
PIN CONTROL SUBSYSTEM
M: Linus Walleij <linus.walleij@linaro.org>
+L: linux-gpio@vger.kernel.org
S: Maintained
F: drivers/pinctrl/
F: include/linux/pinctrl/
diff --git a/drivers/pinctrl/pinctrl-baytrail.c b/drivers/pinctrl/pinctrl-baytrail.c
index e12e5b0..9dc3814 100644
--- a/drivers/pinctrl/pinctrl-baytrail.c
+++ b/drivers/pinctrl/pinctrl-baytrail.c
@@ -227,10 +227,14 @@
spin_lock_irqsave(&vg->lock, flags);
value = readl(reg);
+ WARN(value & BYT_DIRECT_IRQ_EN,
+ "Bad pad config for io mode, force direct_irq_en bit clearing");
+
/* For level trigges the BYT_TRIG_POS and BYT_TRIG_NEG bits
* are used to indicate high and low level triggering
*/
- value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
+ value &= ~(BYT_DIRECT_IRQ_EN | BYT_TRIG_POS | BYT_TRIG_NEG |
+ BYT_TRIG_LVL);
switch (type) {
case IRQ_TYPE_LEVEL_HIGH:
@@ -318,7 +322,7 @@
"Potential Error: Setting GPIO with direct_irq_en to output");
reg_val = readl(reg) | BYT_DIR_MASK;
- reg_val &= ~BYT_OUTPUT_EN;
+ reg_val &= ~(BYT_OUTPUT_EN | BYT_INPUT_EN);
if (value)
writel(reg_val | BYT_LEVEL, reg);
