blob: 2eb9b2b69037f75f07256ae7a17df9ac2272f28a [file] [log] [blame]
Motorola CPCAP PMIC USB PHY binding
Required properties:
compatible: Shall be either "motorola,cpcap-usb-phy" or
"motorola,mapphone-cpcap-usb-phy"
#phy-cells: Shall be 0
interrupts: CPCAP PMIC interrupts used by the USB PHY
interrupt-names: Interrupt names
io-channels: IIO ADC channels used by the USB PHY
io-channel-names: IIO ADC channel names
vusb-supply: Regulator for the PHY
Optional properties:
pinctrl: Optional alternate pin modes for the PHY
pinctrl-names: Names for optional pin modes
mode-gpios: Optional GPIOs for configuring alternate modes
Example:
cpcap_usb2_phy: phy {
compatible = "motorola,mapphone-cpcap-usb-phy";
pinctrl-0 = <&usb_gpio_mux_sel1 &usb_gpio_mux_sel2>;
pinctrl-1 = <&usb_ulpi_pins>;
pinctrl-2 = <&usb_utmi_pins>;
pinctrl-3 = <&uart3_pins>;
pinctrl-names = "default", "ulpi", "utmi", "uart";
#phy-cells = <0>;
interrupts-extended = <
&cpcap 15 0 &cpcap 14 0 &cpcap 28 0 &cpcap 19 0
&cpcap 18 0 &cpcap 17 0 &cpcap 16 0 &cpcap 49 0
&cpcap 48 1
>;
interrupt-names =
"id_ground", "id_float", "se0conn", "vbusvld",
"sessvld", "sessend", "se1", "dm", "dp";
mode-gpios = <&gpio2 28 GPIO_ACTIVE_HIGH
&gpio1 0 GPIO_ACTIVE_HIGH>;
io-channels = <&cpcap_adc 2>, <&cpcap_adc 7>;
io-channel-names = "vbus", "id";
vusb-supply = <&vusb>;
};