Input: ALPS - copy "model" info into alps_data struct
Not every type of ALPS touchpad is well-suited to table-based detection.
Start moving the various alps_model_data attributes into the alps_data
struct so that we don't need a unique table entry for every possible
permutation of protocol version, flags, byte0/mask0, etc.
Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
Tested-by: Dave Turvene <dturvene@dahetral.com>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/mouse/alps.h b/drivers/input/mouse/alps.h
index 67be4e5..efd0eea 100644
--- a/drivers/input/mouse/alps.h
+++ b/drivers/input/mouse/alps.h
@@ -63,10 +63,15 @@
* struct alps_data - private data structure for the ALPS driver
* @dev2: "Relative" device used to report trackstick or mouse activity.
* @phys: Physical path for the relative device.
- * @i: Information on the detected touchpad model.
* @nibble_commands: Command mapping used for touchpad register accesses.
* @addr_command: Command used to tell the touchpad that a register address
* follows.
+ * @proto_version: Indicates V1/V2/V3/...
+ * @byte0: Helps figure out whether a position report packet matches the
+ * known format for this model. The first byte of the report, ANDed with
+ * mask0, should match byte0.
+ * @mask0: The mask used to check the first byte of the report.
+ * @flags: Additional device capabilities (passthrough port, trackstick, etc.).
* @prev_fin: Finger bit from previous packet.
* @multi_packet: Multi-packet data in progress.
* @multi_data: Saved multi-packet data.
@@ -81,9 +86,14 @@
struct alps_data {
struct input_dev *dev2;
char phys[32];
- const struct alps_model_info *i;
+
+ /* these are autodetected when the device is identified */
const struct alps_nibble_commands *nibble_commands;
int addr_command;
+ unsigned char proto_version;
+ unsigned char byte0, mask0;
+ unsigned char flags;
+
int prev_fin;
int multi_packet;
unsigned char multi_data[6];
