cfg80211: consider existing DFS interfaces
It was possible to break interface combinations in
the following way:
combo 1: iftype = AP, num_ifaces = 2, num_chans = 2,
combo 2: iftype = AP, num_ifaces = 1, num_chans = 1, radar = HT20
With the above interface combinations it was
possible to:
step 1. start AP on DFS channel by matching combo 2
step 2. start AP on non-DFS channel by matching combo 1
This was possible beacuse (step 2) did not consider
if other interfaces require radar detection.
The patch changes how cfg80211 tracks channels -
instead of channel itself now a complete chandef
is stored.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/wireless/mesh.c b/net/wireless/mesh.c
index 8858624..d42a3fcb 100644
--- a/net/wireless/mesh.c
+++ b/net/wireless/mesh.c
@@ -195,7 +195,7 @@
if (!err) {
memcpy(wdev->ssid, setup->mesh_id, setup->mesh_id_len);
wdev->mesh_id_len = setup->mesh_id_len;
- wdev->channel = setup->chandef.chan;
+ wdev->chandef = setup->chandef;
}
return err;
@@ -244,7 +244,7 @@
err = rdev_libertas_set_mesh_channel(rdev, wdev->netdev,
chandef->chan);
if (!err)
- wdev->channel = chandef->chan;
+ wdev->chandef = *chandef;
return err;
}
@@ -276,7 +276,7 @@
err = rdev_leave_mesh(rdev, dev);
if (!err) {
wdev->mesh_id_len = 0;
- wdev->channel = NULL;
+ memset(&wdev->chandef, 0, sizeof(wdev->chandef));
rdev_set_qos_map(rdev, dev, NULL);
}
