// SPDX-License-Identifier: BSD-3-Clause
/*
 * Copyright (c) 2020, Konrad Dybcio
 */

#include <dt-bindings/iio/qcom,spmi-vadc.h>
#include <dt-bindings/input/linux-event-codes.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
#include <dt-bindings/thermal/thermal.h>

/ {
	thermal-zones {
		pm660l {
			polling-delay-passive = <250>;
			polling-delay = <1000>;

			thermal-sensors = <&pm660l_temp>;

			trips {
				pm660l_alert0: pm660l-alert0 {
					temperature = <95000>;
					hysteresis = <2000>;
					type = "passive";
				};
				pm660l_crit: pm660l-crit {
					temperature = <125000>;
					hysteresis = <2000>;
					type = "critical";
				};
			};
		};
	};
};

&spmi_bus {

	pmic@2 {
		compatible = "qcom,pm660l", "qcom,spmi-pmic";
		reg = <0x2 SPMI_USID>;
		#address-cells = <1>;
		#size-cells = <0>;

		pm660l_temp: temp-alarm@2400 {
			compatible = "qcom,spmi-temp-alarm";
			reg = <0x2400>;
			interrupts = <0x2 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
			#thermal-sensor-cells = <0>;
		};

		pm660l_gpios: gpios@c000 {
			compatible = "qcom,pm660l-gpio", "qcom,spmi-gpio";
			reg = <0xc000>;
			gpio-controller;
			gpio-ranges = <&pm660l_gpios 0 0 12>;
			#gpio-cells = <2>;
			interrupt-controller;
			#interrupt-cells = <2>;
		};
	};

	pmic@3 {
		compatible = "qcom,pm660l", "qcom,spmi-pmic";
		reg = <0x3 SPMI_USID>;
		#address-cells = <1>;
		#size-cells = <0>;

		pm660l_wled: leds@d800 {
			compatible = "qcom,pm660l-wled";
			reg = <0xd800 0xd900>;
			interrupts = <0x3 0xd8 0x1 IRQ_TYPE_EDGE_RISING>;
			interrupt-names = "ovp";
			label = "backlight";

			qcom,switching-freq = <800>;
			qcom,ovp-millivolt = <29600>;
			qcom,current-boost-limit = <970>;
			qcom,current-limit-microamp = <20000>;
			qcom,num-strings = <2>;
			qcom,enabled-strings = <0 1>;

			status = "disabled";
		};

		pm660l_spmi_regulators: pm660l-regulators {
			compatible = "qcom,pm660l-regulators";
		};
	};
};