blob: 2bc19b1ac877ba1c15d08aa4d5d12076985d88ef [file] [log] [blame]
Broadcom BCM6345-style Level 1 interrupt controller
This block is a first level interrupt controller that is typically connected
directly to one of the HW INT lines on each CPU.
Key elements of the hardware design include:
- 32, 64 or 128 incoming level IRQ lines
- Most onchip peripherals are wired directly to an L1 input
- A separate instance of the register set for each CPU, allowing individual
peripheral IRQs to be routed to any CPU
- Contains one or more enable/status word pairs per CPU
- No atomic set/clear operations
- No polarity/level/edge settings
- No FIFO or priority encoder logic; software is expected to read all
2-4 status words to determine which IRQs are pending
Required properties:
- compatible: should be "brcm,bcm<soc>-l1-intc", "brcm,bcm6345-l1-intc"
- reg: specifies the base physical address and size of the registers;
the number of supported IRQs is inferred from the size argument
- interrupt-controller: identifies the node as an interrupt controller
- #interrupt-cells: specifies the number of cells needed to encode an interrupt
source, should be 1.
- interrupts: specifies the interrupt line(s) in the interrupt-parent controller
node; valid values depend on the type of parent interrupt controller
If multiple reg ranges and interrupt-parent entries are present on an SMP
system, the driver will allow IRQ SMP affinity to be set up through the
/proc/irq/ interface. In the simplest possible configuration, only one
reg range and one interrupt-parent is needed.
The driver operates in native CPU endian by default, there is no support for
specifying an alternative endianness.
Example:
periph_intc: interrupt-controller@10000000 {
compatible = "brcm,bcm63168-l1-intc", "brcm,bcm6345-l1-intc";
reg = <0x10000020 0x20>,
<0x10000040 0x20>;
interrupt-controller;
#interrupt-cells = <1>;
interrupt-parent = <&cpu_intc>;
interrupts = <2>, <3>;
};