Bluetooth: Rename HCI_QUIRK_NO_RESET to HCI_QUIRK_RESET_ON_CLOSE
HCI_QUIRK_NO_RESET name is misleading - purpose of this quirk is to
reset device on close instead of init, not to not reset at all.
Rename it to HCI_QUIRK_RESET_ON_CLOSE to avoid confusion.
Signed-off-by: Szymon Janc <szymon.janc@tieto.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index c9463af..3a6cdc9 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -1026,7 +1026,7 @@
data->isoc = usb_ifnum_to_if(data->udev, 1);
if (!reset)
- set_bit(HCI_QUIRK_NO_RESET, &hdev->quirks);
+ set_bit(HCI_QUIRK_RESET_ON_CLOSE, &hdev->quirks);
if (force_scofix || id->driver_info & BTUSB_WRONG_SCO_MTU) {
if (!disable_scofix)
@@ -1038,7 +1038,7 @@
if (id->driver_info & BTUSB_DIGIANSWER) {
data->cmdreq_type = USB_TYPE_VENDOR;
- set_bit(HCI_QUIRK_NO_RESET, &hdev->quirks);
+ set_bit(HCI_QUIRK_RESET_ON_CLOSE, &hdev->quirks);
}
if (id->driver_info & BTUSB_CSR) {
@@ -1046,7 +1046,7 @@
/* Old firmware would otherwise execute USB reset */
if (le16_to_cpu(udev->descriptor.bcdDevice) < 0x117)
- set_bit(HCI_QUIRK_NO_RESET, &hdev->quirks);
+ set_bit(HCI_QUIRK_RESET_ON_CLOSE, &hdev->quirks);
}
if (id->driver_info & BTUSB_SNIFFER) {
