staging: wfx: add infrastructure for new driver
Instantiate build infrastructure WFx driver. This driver provides support
for Wifi chipset Silicon Labs WF200 and further:
https://www.silabs.com/documents/public/data-sheets/wf200-datasheet.pdf
This chip support SPI and SDIO bus.
SDIO interface has two particularities:
1. Some parameters may be useful for end user (I will talk about
gpio_wakeup later).
2. The SDIO VID and PID of WF200 are 0000:0001 which are too much
generic to rely on.
So, current code checks VID/PID and looks for a node in DT (since WF200
targets embedded platforms, I don't think it is a problem to rely on
DT). DT can also be used to define to parameters for driver. Currently,
if no node is found, a warning is emitted, but it could be changed in
error.
Signed-off-by: Jérôme Pouiller <jerome.pouiller@silabs.com>
Link: https://lore.kernel.org/r/20190919142527.31797-2-Jerome.Pouiller@silabs.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/staging/Makefile b/drivers/staging/Makefile
index a90f9b3..4cb548a 100644
--- a/drivers/staging/Makefile
+++ b/drivers/staging/Makefile
@@ -53,3 +53,4 @@
obj-$(CONFIG_USB_WUSB) += wusbcore/
obj-$(CONFIG_EXFAT_FS) += exfat/
obj-$(CONFIG_QLGE) += qlge/
+obj-$(CONFIG_WFX) += wfx/
