dma-mapping: treat dev->bus_dma_mask as a DMA limit
Using a mask to represent bus DMA constraints has a set of limitations.
The biggest one being it can only hold a power of two (minus one). The
DMA mapping code is already aware of this and treats dev->bus_dma_mask
as a limit. This quirk is already used by some architectures although
still rare.
With the introduction of the Raspberry Pi 4 we've found a new contender
for the use of bus DMA limits, as its PCIe bus can only address the
lower 3GB of memory (of a total of 4GB). This is impossible to represent
with a mask. To make things worse the device-tree code rounds non power
of two bus DMA limits to the next power of two, which is unacceptable in
this case.
In the light of this, rename dev->bus_dma_mask to dev->bus_dma_limit all
over the tree and treat it as such. Note that dev->bus_dma_limit should
contain the higher accessible DMA address.
Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
Reviewed-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>
diff --git a/drivers/of/device.c b/drivers/of/device.c
index da81583..e9127db7 100644
--- a/drivers/of/device.c
+++ b/drivers/of/device.c
@@ -93,7 +93,7 @@ int of_dma_configure(struct device *dev, struct device_node *np, bool force_dma)
bool coherent;
unsigned long offset;
const struct iommu_ops *iommu;
- u64 mask;
+ u64 mask, end;
ret = of_dma_get_range(np, &dma_addr, &paddr, &size);
if (ret < 0) {
@@ -148,12 +148,13 @@ int of_dma_configure(struct device *dev, struct device_node *np, bool force_dma)
* Limit coherent and dma mask based on size and default mask
* set by the driver.
*/
- mask = DMA_BIT_MASK(ilog2(dma_addr + size - 1) + 1);
+ end = dma_addr + size - 1;
+ mask = DMA_BIT_MASK(ilog2(end) + 1);
dev->coherent_dma_mask &= mask;
*dev->dma_mask &= mask;
- /* ...but only set bus mask if we found valid dma-ranges earlier */
+ /* ...but only set bus limit if we found valid dma-ranges earlier */
if (!ret)
- dev->bus_dma_mask = mask;
+ dev->bus_dma_limit = end;
coherent = of_dma_is_coherent(np);
dev_dbg(dev, "device is%sdma coherent\n",
