mfd: twl6040: Correct HPPLL configuration for 19.2 and 38.4 MHz mclk
When the MCLK is 19.2 or 38.4 MHz the HPPLL need to be enabled and can be
put in bypass mode.
This will fix HPPLL use on boards with 19.2MHz mclk.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
diff --git a/drivers/mfd/twl6040.c b/drivers/mfd/twl6040.c
index 12b314e..ae26d84 100644
--- a/drivers/mfd/twl6040.c
+++ b/drivers/mfd/twl6040.c
@@ -441,12 +441,9 @@
TWL6040_HPLLENA;
break;
case 19200000:
- /*
- * PLL disabled
- * (enable PLL if MCLK jitter quality
- * doesn't meet specification)
- */
- hppllctl |= TWL6040_MCLK_19200KHZ;
+ /* PLL enabled, bypass mode */
+ hppllctl |= TWL6040_MCLK_19200KHZ |
+ TWL6040_HPLLBP | TWL6040_HPLLENA;
break;
case 26000000:
/* PLL enabled, active mode */
@@ -454,9 +451,9 @@
TWL6040_HPLLENA;
break;
case 38400000:
- /* PLL enabled, active mode */
+ /* PLL enabled, bypass mode */
hppllctl |= TWL6040_MCLK_38400KHZ |
- TWL6040_HPLLENA;
+ TWL6040_HPLLBP | TWL6040_HPLLENA;
break;
default:
dev_err(twl6040->dev,
