tty: xuartps: Don't write IRQ disable register to enable interrupts
A comment states, that, according to the data sheet, to enable
interrupts the disable register should be written, but the enable
register could be left untouched. And it suspsects a HW bug requiring
to write both.
Reviewing the data sheet, these statements seem wrong. Just as one would
expect. Writing to the enable/disable register enables/disables
interrupts.
Hence the misleading comment and needless write to the disable register
are removed from the enable sequence.
Signed-off-by: Soren Brinkmann <soren.brinkmann@xilinx.com>
Tested-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c
index b182ab8..f9a2c2f 100644
--- a/drivers/tty/serial/xilinx_uartps.c
+++ b/drivers/tty/serial/xilinx_uartps.c
@@ -1085,11 +1085,7 @@
xuartps_writel(ctrl, XUARTPS_CR_OFFSET);
- /* restore interrupt state, it seems like there may be a h/w bug
- * in that the interrupt enable register should not need to be
- * written based on the data sheet
- */
- xuartps_writel(~imr, XUARTPS_IDR_OFFSET);
+ /* restore interrupt state */
xuartps_writel(imr, XUARTPS_IER_OFFSET);
if (locked)
