Bluetooth: btusb: Add CONFIG_BT_HCIBTUSB_POLL_SYNC
This adds CONFIG_BT_HCIBTUSB_POLL_SYNC which can be used to set the
default behavior of Bluetooth USB controller with respect to poll
synchronization of its endpoits.
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>
Tested-by: Tedd Ho-Jeong An <tedd.an@intel.com>
diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
index e307074..fc36057 100644
--- a/drivers/bluetooth/Kconfig
+++ b/drivers/bluetooth/Kconfig
@@ -45,6 +45,16 @@
This can be overridden by passing btusb.enable_autosuspend=[y|n]
on the kernel commandline.
+config BT_HCIBTUSB_POLL_SYNC
+ bool "Enable USB poll_sync for Bluetooth USB devices by default"
+ depends on BT_HCIBTUSB
+ help
+ poll_sync synchronizes the USB data and event endpoints by
+ prioritizing the later.
+
+ Say Y here to enable USB poll_sync for Bluetooth USB devices by
+ default.
+
config BT_HCIBTUSB_BCM
bool "Broadcom protocol support"
depends on BT_HCIBTUSB
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 1a14447..8f34bf1 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -32,6 +32,7 @@
static bool disable_scofix;
static bool force_scofix;
static bool enable_autosuspend = IS_ENABLED(CONFIG_BT_HCIBTUSB_AUTOSUSPEND);
+static bool enable_poll_sync = IS_ENABLED(CONFIG_BT_HCIBTUSB_POLL_SYNC);
static bool reset = true;
static struct usb_driver btusb_driver;
@@ -4075,6 +4076,8 @@ static int btusb_probe(struct usb_interface *intf,
if (enable_autosuspend)
usb_enable_autosuspend(data->udev);
+ data->poll_sync = enable_poll_sync;
+
err = hci_register_dev(hdev);
if (err < 0)
goto out_free_dev;
