ARM: 7219/1: mmc: mmci: Change vdd_handler to a generic ios_handler
The purpose of the vdd_handler does not make sense. We remove it
and use a generic approach instead. A new ios_handler is added, the
purpose of which e.g. can be to control GPIO pins to a levelshifter.
Previously the vdd_handler was also used for making additional
changes to the power register bits. This option is superfluous and is
therefore removed.
Adaptaptions from the old vdd_handler to the new ios_handler is done for
mach-ux500 board, which was the only one using the vdd_handler.
This patch is based upon a patch from Sebastian Rasmussen.
Tested-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sebastian Rasmussen <sebastian.rasmussen@stericsson.com>
Signed-off-by: Ulf Hansson <ulf.hansson@stericsson.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index eb11ce6..0af1507 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -1026,6 +1026,10 @@
unsigned long flags;
int ret;
+ if (host->plat->ios_handler &&
+ host->plat->ios_handler(mmc_dev(mmc), ios))
+ dev_err(mmc_dev(mmc), "platform ios_handler failed\n");
+
switch (ios->power_mode) {
case MMC_POWER_OFF:
if (host->vcc)
@@ -1045,10 +1049,6 @@
return;
}
}
- if (host->plat->vdd_handler)
- pwr |= host->plat->vdd_handler(mmc_dev(mmc), ios->vdd,
- ios->power_mode);
-
/*
* The ST Micro variant doesn't have the PL180s MCI_PWR_UP
* and instead uses MCI_PWR_ON so apply whatever value is
