Input: pixcir_i2c - add support for wake and enable gpios
On some devices the wake and enable pins of the pixcir touchscreen
controller are connected to gpios and these must be controlled by the
driver for the device to operate properly.
Signed-off-by: Sander Vermin <sander@vermin.nl>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/touchscreen/pixcir_i2c_ts.c b/drivers/input/touchscreen/pixcir_i2c_ts.c
index 4b961ad..09523a3 100644
--- a/drivers/input/touchscreen/pixcir_i2c_ts.c
+++ b/drivers/input/touchscreen/pixcir_i2c_ts.c
@@ -38,6 +38,8 @@
struct input_dev *input;
struct gpio_desc *gpio_attb;
struct gpio_desc *gpio_reset;
+ struct gpio_desc *gpio_enable;
+ struct gpio_desc *gpio_wake;
const struct pixcir_i2c_chip_data *chip;
int max_fingers; /* Max fingers supported in this instance */
bool running;
@@ -208,6 +210,11 @@
struct device *dev = &ts->client->dev;
int ret;
+ if (mode == PIXCIR_POWER_ACTIVE || mode == PIXCIR_POWER_IDLE) {
+ if (ts->gpio_wake)
+ gpiod_set_value_cansleep(ts->gpio_wake, 1);
+ }
+
ret = i2c_smbus_read_byte_data(ts->client, PIXCIR_REG_POWER_MODE);
if (ret < 0) {
dev_err(dev, "%s: can't read reg 0x%x : %d\n",
@@ -228,6 +235,11 @@
return ret;
}
+ if (mode == PIXCIR_POWER_HALT) {
+ if (ts->gpio_wake)
+ gpiod_set_value_cansleep(ts->gpio_wake, 0);
+ }
+
return 0;
}
@@ -302,6 +314,11 @@
struct device *dev = &ts->client->dev;
int error;
+ if (ts->gpio_enable) {
+ gpiod_set_value_cansleep(ts->gpio_enable, 1);
+ msleep(100);
+ }
+
/* LEVEL_TOUCH interrupt with active low polarity */
error = pixcir_set_int_mode(ts, PIXCIR_INT_LEVEL_TOUCH, 0);
if (error) {
@@ -343,6 +360,9 @@
/* Wait till running ISR is complete */
synchronize_irq(ts->client->irq);
+ if (ts->gpio_enable)
+ gpiod_set_value_cansleep(ts->gpio_enable, 0);
+
return 0;
}
@@ -534,6 +554,27 @@
return error;
}
+ tsdata->gpio_wake = devm_gpiod_get_optional(dev, "wake",
+ GPIOD_OUT_HIGH);
+ if (IS_ERR(tsdata->gpio_wake)) {
+ error = PTR_ERR(tsdata->gpio_wake);
+ if (error != -EPROBE_DEFER)
+ dev_err(dev, "Failed to get wake gpio: %d\n", error);
+ return error;
+ }
+
+ tsdata->gpio_enable = devm_gpiod_get_optional(dev, "enable",
+ GPIOD_OUT_HIGH);
+ if (IS_ERR(tsdata->gpio_enable)) {
+ error = PTR_ERR(tsdata->gpio_enable);
+ if (error != -EPROBE_DEFER)
+ dev_err(dev, "Failed to get enable gpio: %d\n", error);
+ return error;
+ }
+
+ if (tsdata->gpio_enable)
+ msleep(100);
+
error = devm_request_threaded_irq(dev, client->irq, NULL, pixcir_ts_isr,
IRQF_TRIGGER_FALLING | IRQF_ONESHOT,
client->name, tsdata);
