[PATCH] Kconfig refactoring for better menu nesting
Refactor Kconfig content to maximize nesting of menus by menuconfig and
xconfig.
Tested by simultaneously running `make xconfig` with and without
patch, and comparing displays.
Signed-off-by: Don Mullis <dwm@meer.net>
Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Cc: Sam Ravnborg <sam@ravnborg.org>
Cc: Roman Zippel <zippel@linux-m68k.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
index fc12d5d..0b36dd5c 100644
--- a/drivers/serial/Kconfig
+++ b/drivers/serial/Kconfig
@@ -151,32 +151,6 @@
say N here to save some memory. You can also say Y if you have an
"intelligent" multiport card such as Cyclades, Digiboards, etc.
-config SERIAL_8250_SHARE_IRQ
- bool "Support for sharing serial interrupts"
- depends on SERIAL_8250_EXTENDED
- help
- Some serial boards have hardware support which allows multiple dumb
- serial ports on the same board to share a single IRQ. To enable
- support for this in the serial driver, say Y here.
-
-config SERIAL_8250_DETECT_IRQ
- bool "Autodetect IRQ on standard ports (unsafe)"
- depends on SERIAL_8250_EXTENDED
- help
- Say Y here if you want the kernel to try to guess which IRQ
- to use for your serial port.
-
- This is considered unsafe; it is far better to configure the IRQ in
- a boot script using the setserial command.
-
- If unsure, say N.
-
-config SERIAL_8250_RSA
- bool "Support RSA serial ports"
- depends on SERIAL_8250_EXTENDED
- help
- ::: To be written :::
-
#
# Multi-port serial cards
#
@@ -199,7 +173,6 @@
To compile this driver as a module, choose M here: the module
will be called 8250_accent.
-
config SERIAL_8250_BOCA
tristate "Support Boca cards"
depends on SERIAL_8250 != n && ISA && SERIAL_8250_MANY_PORTS
@@ -230,6 +203,32 @@
To compile this driver as a module, choose M here: the module
will be called 8250_hub6.
+config SERIAL_8250_SHARE_IRQ
+ bool "Support for sharing serial interrupts"
+ depends on SERIAL_8250_EXTENDED
+ help
+ Some serial boards have hardware support which allows multiple dumb
+ serial ports on the same board to share a single IRQ. To enable
+ support for this in the serial driver, say Y here.
+
+config SERIAL_8250_DETECT_IRQ
+ bool "Autodetect IRQ on standard ports (unsafe)"
+ depends on SERIAL_8250_EXTENDED
+ help
+ Say Y here if you want the kernel to try to guess which IRQ
+ to use for your serial port.
+
+ This is considered unsafe; it is far better to configure the IRQ in
+ a boot script using the setserial command.
+
+ If unsure, say N.
+
+config SERIAL_8250_RSA
+ bool "Support RSA serial ports"
+ depends on SERIAL_8250_EXTENDED
+ help
+ ::: To be written :::
+
config SERIAL_8250_MCA
tristate "Support 8250-type ports on MCA buses"
depends on SERIAL_8250 != n && MCA
