mwl8k: force AP mode to use non-AMPDU frames
AP firmware uses xmitcontrol to differentiate between AMPDU
and non-AMPDU frames. As the support for AMPDU is not yet
added, set xmitcontrol to non-AMPDU for all tx frames for AP
firmware. This field will be set to indicate ampdu/non-ampdu
frames when tx AMPDU support is added.
Signed-off-by: Pradeep Nemavat <pnemavat@marvell.com>
Signed-off-by: Brian Cavagnolo <brian@cozybit.com>
Acked-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/mwl8k.c b/drivers/net/wireless/mwl8k.c
index f152a25..1bbcd7c 100644
--- a/drivers/net/wireless/mwl8k.c
+++ b/drivers/net/wireless/mwl8k.c
@@ -1125,10 +1125,12 @@
__le32 reserved;
__le16 rate_info;
__u8 peer_id;
- __u8 tx_frag_cnt;
+ __u8 xmitcontrol;
} __packed;
#define MWL8K_TX_DESCS 128
+#define MWL8K_XMITCONTROL_NON_AMPDU 0x04
+
static int mwl8k_txq_init(struct ieee80211_hw *hw, int index)
{
@@ -1448,6 +1450,9 @@
tx->peer_id = MWL8K_STA(tx_info->control.sta)->peer_id;
else
tx->peer_id = 0;
+
+ if (priv->ap_fw)
+ tx->xmitcontrol = MWL8K_XMITCONTROL_NON_AMPDU;
wmb();
tx->status = cpu_to_le32(MWL8K_TXD_STATUS_FW_OWNED | txstatus);
