mmc: omap_hsmmc: Use OMAP_HSMMC_SUPPORTS_DUAL_VOLT flag to remove host->id based hardcoding
Use OMAP_HSMMC_SUPPORTS_DUAL_VOLT flag instead of host->id
for identifying SD bus voltage capabilities.
Signed-off-by: Balaji T K <balajitk@ti.com>
Signed-off-by: Rajendra Nayak <rnayak@ti.com>
Tested-by: Venkatraman S <svenkatr@ti.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index 3f77fd9..cfb4b48 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -650,7 +650,7 @@
OMAP_HSMMC_WRITE(host->base, SYSCONFIG,
OMAP_HSMMC_READ(host->base, SYSCONFIG) | AUTOIDLE);
- if (host->id == OMAP_MMC1_DEVID) {
+ if (host->pdata->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT) {
if (host->power_mode != MMC_POWER_OFF &&
(1 << ios->vdd) <= MMC_VDD_23_24)
hctl = SDVS18;
