x86: nmi_watchdog - use NMI_NONE by default
There is no need to keep NMI_DISABLED definition and use it
for nmi_watchdog by default. Here is the point why:
- IO-APIC and APIC chips are programmed for nmi_watchdog support at very
early stage of kernel booting and not having nmi_watchdog specified as
boot option lead only to nmi_watchdog becomes to NMI_NONE anyway
- enable nmi_watchdog thru /proc/sys/kernel/nmi if it was not specified at
boot is not possible too (even having this sysfs entry)
Signed-off-by: Cyrill Gorcunov <gorcunov@gmail.com>
Cc: macro@linux-mips.org
Signed-off-by: Ingo Molnar <mingo@elte.hu>
diff --git a/arch/x86/kernel/nmi.c b/arch/x86/kernel/nmi.c
index 427c511..32acda2 100644
--- a/arch/x86/kernel/nmi.c
+++ b/arch/x86/kernel/nmi.c
@@ -52,7 +52,7 @@
atomic_t nmi_active = ATOMIC_INIT(0); /* oprofile uses this */
EXPORT_SYMBOL(nmi_active);
-unsigned int nmi_watchdog = NMI_DEFAULT;
+unsigned int nmi_watchdog = NMI_NONE;
EXPORT_SYMBOL(nmi_watchdog);
static int panic_on_timeout;
@@ -92,14 +92,6 @@
#endif
}
-/* Run after command line and cpu_init init, but before all other checks */
-void nmi_watchdog_default(void)
-{
- if (nmi_watchdog != NMI_DEFAULT)
- return;
- nmi_watchdog = NMI_NONE;
-}
-
#ifdef CONFIG_SMP
/*
* The performance counters used by NMI_LOCAL_APIC don't trigger when
@@ -127,7 +119,7 @@
unsigned int *prev_nmi_count;
int cpu;
- if (nmi_watchdog == NMI_NONE || nmi_watchdog == NMI_DISABLED)
+ if (nmi_watchdog == NMI_NONE)
return 0;
if (!atomic_read(&nmi_active))
@@ -482,24 +474,12 @@
if (!!old_state == !!nmi_watchdog_enabled)
return 0;
- if (atomic_read(&nmi_active) < 0 || nmi_watchdog == NMI_DISABLED) {
+ if (atomic_read(&nmi_active) < 0 || nmi_watchdog == NMI_NONE) {
printk(KERN_WARNING
"NMI watchdog is permanently disabled\n");
return -EIO;
}
- /* if nmi_watchdog is not set yet, then set it */
- nmi_watchdog_default();
-
-#ifdef CONFIG_X86_32
- if (nmi_watchdog == NMI_NONE) {
- if (lapic_watchdog_ok())
- nmi_watchdog = NMI_LOCAL_APIC;
- else
- nmi_watchdog = NMI_IO_APIC;
- }
-#endif
-
if (nmi_watchdog == NMI_LOCAL_APIC) {
if (nmi_watchdog_enabled)
enable_lapic_nmi_watchdog();
