sane irq initialization in sedlbauer hisax
The interrupts schould be disabled until the driver
is ready and the IRQ function was registered.
Thanks to Bastian Friedrich and Thomas Voegtle for spotting this.
Signed-off-by: Karsten Keil <kkeil@suse.de>
Signed-off-by: Bastian Friedrich <bastian@bastian-friedrich.de>
Signed-off-by: Thomas Voegtle <tv@lio96.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/isdn/hisax/sedlbauer.c b/drivers/isdn/hisax/sedlbauer.c
index 030d162..ad06f3c 100644
--- a/drivers/isdn/hisax/sedlbauer.c
+++ b/drivers/isdn/hisax/sedlbauer.c
@@ -451,6 +451,9 @@
spin_unlock_irqrestore(&cs->lock, flags);
return(0);
case CARD_RELEASE:
+ if (cs->hw.sedl.bus == SEDL_BUS_PCI)
+ /* disable all IRQ */
+ byteout(cs->hw.sedl.cfg_reg+ 5, 0);
if (cs->hw.sedl.chip == SEDL_CHIP_ISAC_ISAR) {
spin_lock_irqsave(&cs->lock, flags);
writereg(cs->hw.sedl.adr, cs->hw.sedl.hscx,
@@ -468,6 +471,9 @@
return(0);
case CARD_INIT:
spin_lock_irqsave(&cs->lock, flags);
+ if (cs->hw.sedl.bus == SEDL_BUS_PCI)
+ /* enable all IRQ */
+ byteout(cs->hw.sedl.cfg_reg+ 5, 0x02);
reset_sedlbauer(cs);
if (cs->hw.sedl.chip == SEDL_CHIP_ISAC_ISAR) {
clear_pending_isac_ints(cs);
@@ -667,7 +673,7 @@
byteout(cs->hw.sedl.cfg_reg, 0xff);
byteout(cs->hw.sedl.cfg_reg, 0x00);
byteout(cs->hw.sedl.cfg_reg+ 2, 0xdd);
- byteout(cs->hw.sedl.cfg_reg+ 5, 0x02);
+ byteout(cs->hw.sedl.cfg_reg+ 5, 0); /* disable all IRQ */
byteout(cs->hw.sedl.cfg_reg +3, cs->hw.sedl.reset_on);
mdelay(2);
byteout(cs->hw.sedl.cfg_reg +3, cs->hw.sedl.reset_off);
