Bluetooth: bluecard: blink LED during continuous activity
Currently the activity LED is solid on during continuous activity.
Blink the LED during continuous activity to match Windows driver
behavior.
Cards with activity LED:
power LED = solid on when up, off when down
activity LED = blinking during activity, off when idle
Cards without activity LED:
power LED = solid on when up, off when down, blinking during activity
(don't have such a card so I don't know if Windows driver does the same
thing)
Signed-off-by: Ondrej Zary <linux@rainbow-software.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/drivers/bluetooth/bluecard_cs.c b/drivers/bluetooth/bluecard_cs.c
index 61ac48e..b07ca95 100644
--- a/drivers/bluetooth/bluecard_cs.c
+++ b/drivers/bluetooth/bluecard_cs.c
@@ -93,6 +93,7 @@ static void bluecard_detach(struct pcmcia_device *p_dev);
/* Hardware states */
#define CARD_READY 1
+#define CARD_ACTIVITY 2
#define CARD_HAS_PCCARD_ID 4
#define CARD_HAS_POWER_LED 5
#define CARD_HAS_ACTIVITY_LED 6
@@ -160,13 +161,14 @@ static void bluecard_activity_led_timeout(u_long arg)
struct bluecard_info *info = (struct bluecard_info *)arg;
unsigned int iobase = info->p_dev->resource[0]->start;
- if (test_bit(CARD_HAS_ACTIVITY_LED, &(info->hw_state))) {
- /* Disable activity LED, keep power LED enabled */
- outb(0x08 | 0x20, iobase + 0x30);
- } else {
- /* Disable power LED */
- outb(0x00, iobase + 0x30);
+ if (test_bit(CARD_ACTIVITY, &(info->hw_state))) {
+ /* leave LED in inactive state for HZ/10 for blink effect */
+ clear_bit(CARD_ACTIVITY, &(info->hw_state));
+ mod_timer(&(info->timer), jiffies + HZ / 10);
}
+
+ /* Disable activity LED, enable power LED */
+ outb(0x08 | 0x20, iobase + 0x30);
}
@@ -174,19 +176,22 @@ static void bluecard_enable_activity_led(struct bluecard_info *info)
{
unsigned int iobase = info->p_dev->resource[0]->start;
+ /* don't disturb running blink timer */
+ if (timer_pending(&(info->timer)))
+ return;
+
+ set_bit(CARD_ACTIVITY, &(info->hw_state));
+
if (test_bit(CARD_HAS_ACTIVITY_LED, &(info->hw_state))) {
/* Enable activity LED, keep power LED enabled */
outb(0x18 | 0x60, iobase + 0x30);
-
- /* Stop the LED after HZ/4 */
- mod_timer(&(info->timer), jiffies + HZ / 4);
} else {
- /* Enable power LED */
- outb(0x08 | 0x20, iobase + 0x30);
-
- /* Stop the LED after HZ/2 */
- mod_timer(&(info->timer), jiffies + HZ / 2);
+ /* Disable power LED */
+ outb(0x00, iobase + 0x30);
}
+
+ /* Stop the LED after HZ/10 */
+ mod_timer(&(info->timer), jiffies + HZ / 10);
}
