.TH CPUPOWER\-SET "1" "22/02/2011" "" "cpupower Manual"
.SH NAME
cpupower\-set \- Set processor power related kernel or hardware configurations
.SH SYNOPSIS
.ft B
.B cpupower set [ \-b VAL | \-e POLICY | \-m MODE | \-t BOOL ]


.SH DESCRIPTION
\fBcpupower set \fP sets kernel configurations or directly accesses hardware
registers affecting processor power saving policies.

Some options are platform wide, some affect single cores. By default values
are applied on all cores. How to modify single core configurations is
described in the cpupower(1) manpage in the \-\-cpu option section. Whether an
option affects the whole system or can be applied to individual cores is
described in the Options sections.

Use \fBcpupower info \fP to read out current settings and whether they are
supported on the system at all.

.SH OPTIONS
.PP
\-\-perf-bias, \-b
.RS 4
Sets a register on supported Intel processore which allows software to convey
its policy for the relative importance of performance versus energy savings to
the  processor.

The range of valid numbers is 0-15, where 0 is maximum
performance and 15 is maximum energy efficiency.

The processor uses this information in model-specific ways
when it must select trade-offs between performance and
energy efficiency.

This policy hint does not supersede Processor Performance states
(P-states) or CPU Idle power states (C-states), but allows
software to have influence where it would otherwise be unable
to express a preference.

For example, this setting may tell the hardware how
aggressively or conservatively to control frequency
in the "turbo range" above the explicitly OS-controlled
P-state frequency range.  It may also tell the hardware
how aggressively it should enter the OS requested C-states.

This option can be applied to individual cores only via the \-\-cpu option,
cpupower(1).

Setting the performance bias value on one CPU can modify the setting on
related CPUs as well (for example all CPUs on one socket), because of
hardware restrictions.
Use \fBcpupower -c all info -b\fP to verify.

This options needs the msr kernel driver (CONFIG_X86_MSR) loaded.
.RE

.PP
\-\-epp, \-e
.RS 4
Sets the energy performance policy preference on supported Intel or AMD
processors which use the Intel or AMD P-State cpufreq driver respectively.

Available policies can be found with
\fBcat /sys/devices/system/cpu/cpufreq/policy0/energy_performance_available_preferences\fP :
.RS 4
default performance balance_performance balance_power power
.RE

.RE

.PP
\-\-amd\-pstate\-mode, \-m
.RS 4
Sets the AMD P-State mode for supported AMD processors.
Available modes are "active", "guided" or "passive".

Refer to the AMD P-State kernel documentation for further information.

.RE

.PP
\-\-turbo\-boost, \-t
.RS 4
This option is used to enable or disable the turbo boost feature on
supported Intel and AMD processors.

This option takes as parameter either \fB1\fP to enable, or \fB0\fP to disable the feature.

.RE

.SH "SEE ALSO"
cpupower-info(1), cpupower-monitor(1), powertop(1)
.PP
.SH AUTHORS
.nf
\-\-perf\-bias parts written by Len Brown <len.brown@intel.com>
Thomas Renninger <trenn@suse.de>