| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright (c) 2022 MediaTek Inc. |
| * Author: Jianjun Wang <jianjun.wang@mediatek.com> |
| */ |
| |
| #include <linux/bitfield.h> |
| #include <linux/module.h> |
| #include <linux/nvmem-consumer.h> |
| #include <linux/of_device.h> |
| #include <linux/phy/phy.h> |
| #include <linux/platform_device.h> |
| #include <linux/slab.h> |
| |
| #include "phy-mtk-io.h" |
| |
| #define PEXTP_ANA_GLB_00_REG 0x9000 |
| /* Internal Resistor Selection of TX Bias Current */ |
| #define EFUSE_GLB_INTR_SEL GENMASK(28, 24) |
| |
| #define PEXTP_ANA_LN0_TRX_REG 0xa000 |
| |
| #define PEXTP_ANA_TX_REG 0x04 |
| /* TX PMOS impedance selection */ |
| #define EFUSE_LN_TX_PMOS_SEL GENMASK(5, 2) |
| /* TX NMOS impedance selection */ |
| #define EFUSE_LN_TX_NMOS_SEL GENMASK(11, 8) |
| |
| #define PEXTP_ANA_RX_REG 0x3c |
| /* RX impedance selection */ |
| #define EFUSE_LN_RX_SEL GENMASK(3, 0) |
| |
| #define PEXTP_ANA_LANE_OFFSET 0x100 |
| |
| /** |
| * struct mtk_pcie_lane_efuse - eFuse data for each lane |
| * @tx_pmos: TX PMOS impedance selection data |
| * @tx_nmos: TX NMOS impedance selection data |
| * @rx_data: RX impedance selection data |
| * @lane_efuse_supported: software eFuse data is supported for this lane |
| */ |
| struct mtk_pcie_lane_efuse { |
| u32 tx_pmos; |
| u32 tx_nmos; |
| u32 rx_data; |
| bool lane_efuse_supported; |
| }; |
| |
| /** |
| * struct mtk_pcie_phy_data - phy data for each SoC |
| * @num_lanes: supported lane numbers |
| * @sw_efuse_supported: support software to load eFuse data |
| */ |
| struct mtk_pcie_phy_data { |
| int num_lanes; |
| bool sw_efuse_supported; |
| }; |
| |
| /** |
| * struct mtk_pcie_phy - PCIe phy driver main structure |
| * @dev: pointer to device |
| * @phy: pointer to generic phy |
| * @sif_base: IO mapped register base address of system interface |
| * @data: pointer to SoC dependent data |
| * @sw_efuse_en: software eFuse enable status |
| * @efuse_glb_intr: internal resistor selection of TX bias current data |
| * @efuse: pointer to eFuse data for each lane |
| */ |
| struct mtk_pcie_phy { |
| struct device *dev; |
| struct phy *phy; |
| void __iomem *sif_base; |
| const struct mtk_pcie_phy_data *data; |
| |
| bool sw_efuse_en; |
| u32 efuse_glb_intr; |
| struct mtk_pcie_lane_efuse *efuse; |
| }; |
| |
| static void mtk_pcie_efuse_set_lane(struct mtk_pcie_phy *pcie_phy, |
| unsigned int lane) |
| { |
| struct mtk_pcie_lane_efuse *data = &pcie_phy->efuse[lane]; |
| void __iomem *addr; |
| |
| if (!data->lane_efuse_supported) |
| return; |
| |
| addr = pcie_phy->sif_base + PEXTP_ANA_LN0_TRX_REG + |
| lane * PEXTP_ANA_LANE_OFFSET; |
| |
| mtk_phy_update_field(addr + PEXTP_ANA_TX_REG, EFUSE_LN_TX_PMOS_SEL, |
| data->tx_pmos); |
| |
| mtk_phy_update_field(addr + PEXTP_ANA_TX_REG, EFUSE_LN_TX_NMOS_SEL, |
| data->tx_nmos); |
| |
| mtk_phy_update_field(addr + PEXTP_ANA_RX_REG, EFUSE_LN_RX_SEL, |
| data->rx_data); |
| } |
| |
| /** |
| * mtk_pcie_phy_init() - Initialize the phy |
| * @phy: the phy to be initialized |
| * |
| * Initialize the phy by setting the efuse data. |
| * The hardware settings will be reset during suspend, it should be |
| * reinitialized when the consumer calls phy_init() again on resume. |
| */ |
| static int mtk_pcie_phy_init(struct phy *phy) |
| { |
| struct mtk_pcie_phy *pcie_phy = phy_get_drvdata(phy); |
| int i; |
| |
| if (!pcie_phy->sw_efuse_en) |
| return 0; |
| |
| /* Set global data */ |
| mtk_phy_update_field(pcie_phy->sif_base + PEXTP_ANA_GLB_00_REG, |
| EFUSE_GLB_INTR_SEL, pcie_phy->efuse_glb_intr); |
| |
| for (i = 0; i < pcie_phy->data->num_lanes; i++) |
| mtk_pcie_efuse_set_lane(pcie_phy, i); |
| |
| return 0; |
| } |
| |
| static const struct phy_ops mtk_pcie_phy_ops = { |
| .init = mtk_pcie_phy_init, |
| .owner = THIS_MODULE, |
| }; |
| |
| static int mtk_pcie_efuse_read_for_lane(struct mtk_pcie_phy *pcie_phy, |
| unsigned int lane) |
| { |
| struct mtk_pcie_lane_efuse *efuse = &pcie_phy->efuse[lane]; |
| struct device *dev = pcie_phy->dev; |
| char efuse_id[16]; |
| int ret; |
| |
| snprintf(efuse_id, sizeof(efuse_id), "tx_ln%d_pmos", lane); |
| ret = nvmem_cell_read_variable_le_u32(dev, efuse_id, &efuse->tx_pmos); |
| if (ret) |
| return dev_err_probe(dev, ret, "Failed to read %s\n", efuse_id); |
| |
| snprintf(efuse_id, sizeof(efuse_id), "tx_ln%d_nmos", lane); |
| ret = nvmem_cell_read_variable_le_u32(dev, efuse_id, &efuse->tx_nmos); |
| if (ret) |
| return dev_err_probe(dev, ret, "Failed to read %s\n", efuse_id); |
| |
| snprintf(efuse_id, sizeof(efuse_id), "rx_ln%d", lane); |
| ret = nvmem_cell_read_variable_le_u32(dev, efuse_id, &efuse->rx_data); |
| if (ret) |
| return dev_err_probe(dev, ret, "Failed to read %s\n", efuse_id); |
| |
| if (!(efuse->tx_pmos || efuse->tx_nmos || efuse->rx_data)) |
| return dev_err_probe(dev, -EINVAL, |
| "No eFuse data found for lane%d, but dts enable it\n", |
| lane); |
| |
| efuse->lane_efuse_supported = true; |
| |
| return 0; |
| } |
| |
| static int mtk_pcie_read_efuse(struct mtk_pcie_phy *pcie_phy) |
| { |
| struct device *dev = pcie_phy->dev; |
| bool nvmem_enabled; |
| int ret, i; |
| |
| /* nvmem data is optional */ |
| nvmem_enabled = device_property_present(dev, "nvmem-cells"); |
| if (!nvmem_enabled) |
| return 0; |
| |
| ret = nvmem_cell_read_variable_le_u32(dev, "glb_intr", |
| &pcie_phy->efuse_glb_intr); |
| if (ret) |
| return dev_err_probe(dev, ret, "Failed to read glb_intr\n"); |
| |
| pcie_phy->sw_efuse_en = true; |
| |
| pcie_phy->efuse = devm_kzalloc(dev, pcie_phy->data->num_lanes * |
| sizeof(*pcie_phy->efuse), GFP_KERNEL); |
| if (!pcie_phy->efuse) |
| return -ENOMEM; |
| |
| for (i = 0; i < pcie_phy->data->num_lanes; i++) { |
| ret = mtk_pcie_efuse_read_for_lane(pcie_phy, i); |
| if (ret) |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static int mtk_pcie_phy_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct phy_provider *provider; |
| struct mtk_pcie_phy *pcie_phy; |
| int ret; |
| |
| pcie_phy = devm_kzalloc(dev, sizeof(*pcie_phy), GFP_KERNEL); |
| if (!pcie_phy) |
| return -ENOMEM; |
| |
| pcie_phy->sif_base = devm_platform_ioremap_resource_byname(pdev, "sif"); |
| if (IS_ERR(pcie_phy->sif_base)) |
| return dev_err_probe(dev, PTR_ERR(pcie_phy->sif_base), |
| "Failed to map phy-sif base\n"); |
| |
| pcie_phy->phy = devm_phy_create(dev, dev->of_node, &mtk_pcie_phy_ops); |
| if (IS_ERR(pcie_phy->phy)) |
| return dev_err_probe(dev, PTR_ERR(pcie_phy->phy), |
| "Failed to create PCIe phy\n"); |
| |
| pcie_phy->dev = dev; |
| pcie_phy->data = of_device_get_match_data(dev); |
| if (!pcie_phy->data) |
| return dev_err_probe(dev, -EINVAL, "Failed to get phy data\n"); |
| |
| if (pcie_phy->data->sw_efuse_supported) { |
| /* |
| * Failed to read the efuse data is not a fatal problem, |
| * ignore the failure and keep going. |
| */ |
| ret = mtk_pcie_read_efuse(pcie_phy); |
| if (ret == -EPROBE_DEFER || ret == -ENOMEM) |
| return ret; |
| } |
| |
| phy_set_drvdata(pcie_phy->phy, pcie_phy); |
| |
| provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate); |
| if (IS_ERR(provider)) |
| return dev_err_probe(dev, PTR_ERR(provider), |
| "PCIe phy probe failed\n"); |
| |
| return 0; |
| } |
| |
| static const struct mtk_pcie_phy_data mt8195_data = { |
| .num_lanes = 2, |
| .sw_efuse_supported = true, |
| }; |
| |
| static const struct of_device_id mtk_pcie_phy_of_match[] = { |
| { .compatible = "mediatek,mt8195-pcie-phy", .data = &mt8195_data }, |
| { }, |
| }; |
| MODULE_DEVICE_TABLE(of, mtk_pcie_phy_of_match); |
| |
| static struct platform_driver mtk_pcie_phy_driver = { |
| .probe = mtk_pcie_phy_probe, |
| .driver = { |
| .name = "mtk-pcie-phy", |
| .of_match_table = mtk_pcie_phy_of_match, |
| }, |
| }; |
| module_platform_driver(mtk_pcie_phy_driver); |
| |
| MODULE_DESCRIPTION("MediaTek PCIe PHY driver"); |
| MODULE_AUTHOR("Jianjun Wang <jianjun.wang@mediatek.com>"); |
| MODULE_LICENSE("GPL"); |