be2net: Workaround to fix a bug in Rx Completion processing.
vtp bit in RX completion descriptor could be wrongly set in
some skews of BladEngine. Ignore this bit if vtm is not set.
Resending because the previous patch was against net-next tree.
This patch is against the net-2.6 tree.
Signed-off-by: Ajit Khaparde <ajitk@serverengines.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/benet/be_main.c b/drivers/net/benet/be_main.c
index 409cf05..2f9b501 100644
--- a/drivers/net/benet/be_main.c
+++ b/drivers/net/benet/be_main.c
@@ -747,9 +747,16 @@
struct be_eth_rx_compl *rxcp)
{
struct sk_buff *skb;
- u32 vtp, vid;
+ u32 vlanf, vid;
+ u8 vtm;
- vtp = AMAP_GET_BITS(struct amap_eth_rx_compl, vtp, rxcp);
+ vlanf = AMAP_GET_BITS(struct amap_eth_rx_compl, vtp, rxcp);
+ vtm = AMAP_GET_BITS(struct amap_eth_rx_compl, vtm, rxcp);
+
+ /* vlanf could be wrongly set in some cards.
+ * ignore if vtm is not set */
+ if ((adapter->cap == 0x400) && !vtm)
+ vlanf = 0;
skb = netdev_alloc_skb(adapter->netdev, BE_HDR_LEN + NET_IP_ALIGN);
if (!skb) {
@@ -772,7 +779,7 @@
skb->protocol = eth_type_trans(skb, adapter->netdev);
skb->dev = adapter->netdev;
- if (vtp) {
+ if (vlanf) {
if (!adapter->vlan_grp || adapter->num_vlans == 0) {
kfree_skb(skb);
return;
@@ -797,11 +804,18 @@
struct be_eq_obj *eq_obj = &adapter->rx_eq;
u32 num_rcvd, pkt_size, remaining, vlanf, curr_frag_len;
u16 i, rxq_idx = 0, vid, j;
+ u8 vtm;
num_rcvd = AMAP_GET_BITS(struct amap_eth_rx_compl, numfrags, rxcp);
pkt_size = AMAP_GET_BITS(struct amap_eth_rx_compl, pktsize, rxcp);
vlanf = AMAP_GET_BITS(struct amap_eth_rx_compl, vtp, rxcp);
rxq_idx = AMAP_GET_BITS(struct amap_eth_rx_compl, fragndx, rxcp);
+ vtm = AMAP_GET_BITS(struct amap_eth_rx_compl, vtm, rxcp);
+
+ /* vlanf could be wrongly set in some cards.
+ * ignore if vtm is not set */
+ if ((adapter->cap == 0x400) && !vtm)
+ vlanf = 0;
skb = napi_get_frags(&eq_obj->napi);
if (!skb) {
@@ -2045,7 +2059,8 @@
if (status)
return status;
- status = be_cmd_query_fw_cfg(adapter, &adapter->port_num);
+ status = be_cmd_query_fw_cfg(adapter,
+ &adapter->port_num, &adapter->cap);
return status;
}
