dmaengine: fsl-edma: add ColdFire mcf5441x edma support
This patch adds support for ColdFire mcf5441x-family edma
module.
The ColdFire edma module is slightly different from fsl-edma,
so a new driver is added. But most of the code is common
between fsl-edma and mcf-edma so it has been collected into a
separate common module fsl-edma-common (patch 1/3).
Signed-off-by: Angelo Dureghello <angelo@sysam.it>
Tested-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
diff --git a/drivers/dma/Kconfig b/drivers/dma/Kconfig
index dacf3f4..0510432 100644
--- a/drivers/dma/Kconfig
+++ b/drivers/dma/Kconfig
@@ -321,6 +321,17 @@
Enable support for DMA on NXP LPC18xx/43xx platforms
with PL080 and multiplexed DMA request lines.
+config MCF_EDMA
+ tristate "Freescale eDMA engine support, ColdFire mcf5441x SoCs"
+ depends on M5441x || COMPILE_TEST
+ select DMA_ENGINE
+ select DMA_VIRTUAL_CHANNELS
+ help
+ Support the Freescale ColdFire eDMA engine, 64-channel
+ implementation that performs complex data transfers with
+ minimal intervention from a host processor.
+ This module can be found on Freescale ColdFire mcf5441x SoCs.
+
config MMP_PDMA
bool "MMP PDMA support"
depends on ARCH_MMP || ARCH_PXA || COMPILE_TEST
