# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/fpga/xlnx,fpga-slave-serial.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Xilinx Slave Serial SPI FPGA

maintainers:
  - Nava kishore Manne <nava.kishore.manne@amd.com>

description: |
  Xilinx Spartan-6 and 7 Series FPGAs support a method of loading the bitstream
  over what is referred to as slave serial interface.The slave serial link is
  not technically SPI, and might require extra circuits in order to play nicely
  with other SPI slaves on the same bus.

  Datasheets:
    https://www.xilinx.com/support/documentation/user_guides/ug380.pdf
    https://www.xilinx.com/support/documentation/user_guides/ug470_7Series_Config.pdf
    https://www.xilinx.com/support/documentation/application_notes/xapp583-fpga-configuration.pdf

allOf:
  - $ref: /schemas/spi/spi-peripheral-props.yaml#

properties:
  compatible:
    enum:
      - xlnx,fpga-slave-serial

  spi-cpha: true

  spi-max-frequency:
    maximum: 60000000

  reg:
    maxItems: 1

  prog_b-gpios:
    description:
      config pin (referred to as PROGRAM_B in the manual)
    maxItems: 1

  done-gpios:
    description:
      config status pin (referred to as DONE in the manual)
    maxItems: 1

  init-b-gpios:
    description:
      initialization status and configuration error pin
      (referred to as INIT_B in the manual)
    maxItems: 1

required:
  - compatible
  - reg
  - prog_b-gpios
  - done-gpios
  - init-b-gpios

additionalProperties: false

examples:
  - |
    #include <dt-bindings/gpio/gpio.h>
    spi {
      #address-cells = <1>;
      #size-cells = <0>;
      fpga_mgr_spi: fpga-mgr@0 {
        compatible = "xlnx,fpga-slave-serial";
        spi-max-frequency = <60000000>;
        spi-cpha;
        reg = <0>;
        prog_b-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
        init-b-gpios = <&gpio0 28 GPIO_ACTIVE_LOW>;
        done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
      };
    };
...