arcnet: Use network block comment style
Conformity can be useful.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
diff --git a/drivers/net/arcnet/rfc1051.c b/drivers/net/arcnet/rfc1051.c
index ed7b645..e78b765 100644
--- a/drivers/net/arcnet/rfc1051.c
+++ b/drivers/net/arcnet/rfc1051.c
@@ -78,8 +78,7 @@
MODULE_LICENSE("GPL");
-/*
- * Determine a packet's protocol ID.
+/* Determine a packet's protocol ID.
*
* With ARCnet we have to convert everything to Ethernet-style stuff.
*/
@@ -156,9 +155,7 @@
netif_rx(skb);
}
-/*
- * Create the ARCnet hard/soft headers for RFC1051.
- */
+/* Create the ARCnet hard/soft headers for RFC1051 */
static int build_header(struct sk_buff *skb, struct net_device *dev,
unsigned short type, uint8_t daddr)
{
@@ -182,21 +179,19 @@
return 0;
}
- /*
- * Set the source hardware address.
+ /* Set the source hardware address.
*
* This is pretty pointless for most purposes, but it can help in
- * debugging. ARCnet does not allow us to change the source address in
- * the actual packet sent)
+ * debugging. ARCnet does not allow us to change the source address
+ * in the actual packet sent.
*/
pkt->hard.source = *dev->dev_addr;
/* see linux/net/ethernet/eth.c to see where I got the following */
if (dev->flags & (IFF_LOOPBACK | IFF_NOARP)) {
- /*
- * FIXME: fill in the last byte of the dest ipaddr here to better
- * comply with RFC1051 in "noarp" mode.
+ /* FIXME: fill in the last byte of the dest ipaddr here to
+ * better comply with RFC1051 in "noarp" mode.
*/
pkt->hard.dest = 0;
return hdr_size;
