/* SPDX-License-Identifier: LGPL-2.1 OR MIT */

/*
 * RSEQ_SIG uses the trap4 instruction. As Linux does not make use of the
 * access-register mode nor the linkage stack this instruction will always
 * cause a special-operation exception (the trap-enabled bit in the DUCT
 * is and will stay 0). The instruction pattern is
 *	b2 ff 0f ff	trap4	4095(%r0)
 */
#define RSEQ_SIG	0xB2FF0FFF

#define rseq_smp_mb()	__asm__ __volatile__ ("bcr 15,0" ::: "memory")
#define rseq_smp_rmb()	rseq_smp_mb()
#define rseq_smp_wmb()	rseq_smp_mb()

#define rseq_smp_load_acquire(p)					\
__extension__ ({							\
	rseq_unqual_scalar_typeof(*(p)) ____p1 = RSEQ_READ_ONCE(*(p));	\
	rseq_barrier();							\
	____p1;								\
})

#define rseq_smp_acquire__after_ctrl_dep()	rseq_smp_rmb()

#define rseq_smp_store_release(p, v)					\
do {									\
	rseq_barrier();							\
	RSEQ_WRITE_ONCE(*(p), v);					\
} while (0)

#define LONG_L			"lg"
#define LONG_S			"stg"
#define LONG_LT_R		"ltgr"
#define LONG_CMP		"cg"
#define LONG_CMP_R		"cgr"
#define LONG_ADDI		"aghi"
#define LONG_ADD_R		"agr"

#define __RSEQ_ASM_DEFINE_TABLE(label, version, flags,			\
				start_ip, post_commit_offset, abort_ip)	\
		".pushsection __rseq_cs, \"aw\"\n\t"			\
		".balign 32\n\t"					\
		__rseq_str(label) ":\n\t"				\
		".long " __rseq_str(version) ", " __rseq_str(flags) "\n\t" \
		".quad " __rseq_str(start_ip) ", " __rseq_str(post_commit_offset) ", " __rseq_str(abort_ip) "\n\t" \
		".popsection\n\t"					\
		".pushsection __rseq_cs_ptr_array, \"aw\"\n\t"		\
		".quad " __rseq_str(label) "b\n\t"			\
		".popsection\n\t"

/*
 * Exit points of a rseq critical section consist of all instructions outside
 * of the critical section where a critical section can either branch to or
 * reach through the normal course of its execution. The abort IP and the
 * post-commit IP are already part of the __rseq_cs section and should not be
 * explicitly defined as additional exit points. Knowing all exit points is
 * useful to assist debuggers stepping over the critical section.
 */
#define RSEQ_ASM_DEFINE_EXIT_POINT(start_ip, exit_ip)			\
		".pushsection __rseq_exit_point_array, \"aw\"\n\t"	\
		".quad " __rseq_str(start_ip) ", " __rseq_str(exit_ip) "\n\t" \
		".popsection\n\t"

#define RSEQ_ASM_DEFINE_TABLE(label, start_ip, post_commit_ip, abort_ip) \
	__RSEQ_ASM_DEFINE_TABLE(label, 0x0, 0x0, start_ip,		\
				(post_commit_ip - start_ip), abort_ip)

#define RSEQ_ASM_STORE_RSEQ_CS(label, cs_label, rseq_cs)		\
		RSEQ_INJECT_ASM(1)					\
		"larl %%r0, " __rseq_str(cs_label) "\n\t"		\
		LONG_S " %%r0, %[" __rseq_str(rseq_cs) "]\n\t"		\
		__rseq_str(label) ":\n\t"

#define RSEQ_ASM_CMP_CPU_ID(cpu_id, current_cpu_id, label)		\
		RSEQ_INJECT_ASM(2)					\
		"c %[" __rseq_str(cpu_id) "], %[" __rseq_str(current_cpu_id) "]\n\t" \
		"jnz " __rseq_str(label) "\n\t"

#define RSEQ_ASM_DEFINE_ABORT(label, teardown, abort_label)		\
		".pushsection __rseq_failure, \"ax\"\n\t"		\
		".long " __rseq_str(RSEQ_SIG) "\n\t"			\
		__rseq_str(label) ":\n\t"				\
		teardown						\
		"jg %l[" __rseq_str(abort_label) "]\n\t"		\
		".popsection\n\t"

#define RSEQ_ASM_DEFINE_CMPFAIL(label, teardown, cmpfail_label)		\
		".pushsection __rseq_failure, \"ax\"\n\t"		\
		__rseq_str(label) ":\n\t"				\
		teardown						\
		"jg %l[" __rseq_str(cmpfail_label) "]\n\t"		\
		".popsection\n\t"

/* Per-cpu-id indexing. */

#define RSEQ_TEMPLATE_CPU_ID
#define RSEQ_TEMPLATE_MO_RELAXED
#include "rseq-s390-bits.h"
#undef RSEQ_TEMPLATE_MO_RELAXED

#define RSEQ_TEMPLATE_MO_RELEASE
#include "rseq-s390-bits.h"
#undef RSEQ_TEMPLATE_MO_RELEASE
#undef RSEQ_TEMPLATE_CPU_ID

/* Per-mm-cid indexing. */

#define RSEQ_TEMPLATE_MM_CID
#define RSEQ_TEMPLATE_MO_RELAXED
#include "rseq-s390-bits.h"
#undef RSEQ_TEMPLATE_MO_RELAXED

#define RSEQ_TEMPLATE_MO_RELEASE
#include "rseq-s390-bits.h"
#undef RSEQ_TEMPLATE_MO_RELEASE
#undef RSEQ_TEMPLATE_MM_CID

/* APIs which are not based on cpu ids. */

#define RSEQ_TEMPLATE_CPU_ID_NONE
#define RSEQ_TEMPLATE_MO_RELAXED
#include "rseq-s390-bits.h"
#undef RSEQ_TEMPLATE_MO_RELAXED
#undef RSEQ_TEMPLATE_CPU_ID_NONE