loop: unset GENHD_FL_NO_PART_SCAN on LOOP_CONFIGURE
When LOOP_CONFIGURE is used with LO_FLAGS_PARTSCAN we need to propagate
this into the GENHD_FL_NO_PART_SCAN. LOOP_SETSTATUS does this,
LOOP_CONFIGURE doesn't so far. Effect is that setting up a loopback
device with partition scanning doesn't actually work when LOOP_CONFIGURE
is issued, though it works fine with LOOP_SETSTATUS.
Let's correct that and propagate the flag in LOOP_CONFIGURE too.
Fixes: 3448914e8cc5("loop: Add LOOP_CONFIGURE ioctl")
Signed-off-by: Lennart Poettering <lennart@poettering.net>
Acked-by: Martijn Coenen <maco@android.com>
Signed-off-by: Jens Axboe <axboe@kernel.dk>
diff --git a/drivers/block/loop.c b/drivers/block/loop.c
index d181601..2f137d6c 100644
--- a/drivers/block/loop.c
+++ b/drivers/block/loop.c
@@ -1171,6 +1171,8 @@ static int loop_configure(struct loop_device *lo, fmode_t mode,
if (part_shift)
lo->lo_flags |= LO_FLAGS_PARTSCAN;
partscan = lo->lo_flags & LO_FLAGS_PARTSCAN;
+ if (partscan)
+ lo->lo_disk->flags &= ~GENHD_FL_NO_PART_SCAN;
/* Grab the block_device to prevent its destruction after we
* put /dev/loopXX inode. Later in __loop_clr_fd() we bdput(bdev).
