[media] xc4000: use if_khz provided in xc4000_config
Remove hard-coded references to 5400, using the value passed in when the
xc4000 is attached.
Signed-off-by: Devin Heitmueller <dheitmueller@kernellabs.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/common/tuners/xc4000.c b/drivers/media/common/tuners/xc4000.c
index 65d07eb..2dacf20 100644
--- a/drivers/media/common/tuners/xc4000.c
+++ b/drivers/media/common/tuners/xc4000.c
@@ -883,7 +883,7 @@
u8 scode_buf[13];
u8 indirect_mode[5];
- dprintk(1, "%s called\n", __func__);
+ dprintk(1, "%s called int_freq=%d\n", __func__, int_freq);
if (!int_freq) {
pos = seek_firmware(fe, type, id);
@@ -1186,7 +1186,7 @@
dprintk(1, "%s() frequency=%d (Hz)\n", __func__, params->frequency);
/* FIXME: setup proper parameters */
- if (check_firmware(fe, DTV8, 0, 5400) != XC_RESULT_SUCCESS) {
+ if (check_firmware(fe, DTV8, 0, priv->if_khz) != XC_RESULT_SUCCESS) {
return -EREMOTEIO;
}
@@ -1302,7 +1302,7 @@
__func__, params->frequency);
/* FIXME: setup proper parameters */
- if (check_firmware(fe, DTV8, 0, 5400) != XC_RESULT_SUCCESS) {
+ if (check_firmware(fe, DTV8, 0, priv->if_khz) != XC_RESULT_SUCCESS) {
return -EREMOTEIO;
}
@@ -1424,7 +1424,7 @@
struct xc4000_priv *priv = fe->tuner_priv;
dprintk(1, "%s()\n", __func__);
- if (check_firmware(fe, DTV8, 0, 5400) != XC_RESULT_SUCCESS) {
+ if (check_firmware(fe, DTV8, 0, priv->if_khz) != XC_RESULT_SUCCESS) {
printk(KERN_ERR "xc4000: Unable to initialise tuner\n");
return -EREMOTEIO;
}
@@ -1547,7 +1547,7 @@
/* FIXME: For now, load the firmware at startup. We will remove this
before the code goes to production... */
- check_firmware(fe, DTV8, 0, 5400);
+ check_firmware(fe, DTV8, 0, priv->if_khz);
return fe;
fail:
