| // SPDX-License-Identifier: GPL-2.0-only |
| |
| #include <linux/ethtool.h> |
| #include <linux/sfp.h> |
| #include "netlink.h" |
| #include "common.h" |
| |
| struct eeprom_req_info { |
| struct ethnl_req_info base; |
| u32 offset; |
| u32 length; |
| u8 page; |
| u8 bank; |
| u8 i2c_address; |
| }; |
| |
| struct eeprom_reply_data { |
| struct ethnl_reply_data base; |
| u32 length; |
| u8 *data; |
| }; |
| |
| #define MODULE_EEPROM_REQINFO(__req_base) \ |
| container_of(__req_base, struct eeprom_req_info, base) |
| |
| #define MODULE_EEPROM_REPDATA(__reply_base) \ |
| container_of(__reply_base, struct eeprom_reply_data, base) |
| |
| static int fallback_set_params(struct eeprom_req_info *request, |
| struct ethtool_modinfo *modinfo, |
| struct ethtool_eeprom *eeprom) |
| { |
| u32 offset = request->offset; |
| u32 length = request->length; |
| |
| if (request->page) |
| offset = request->page * ETH_MODULE_EEPROM_PAGE_LEN + offset; |
| |
| if (modinfo->type == ETH_MODULE_SFF_8472 && |
| request->i2c_address == 0x51) |
| offset += ETH_MODULE_EEPROM_PAGE_LEN * 2; |
| |
| if (offset >= modinfo->eeprom_len) |
| return -EINVAL; |
| |
| eeprom->cmd = ETHTOOL_GMODULEEEPROM; |
| eeprom->len = length; |
| eeprom->offset = offset; |
| |
| return 0; |
| } |
| |
| static int eeprom_fallback(struct eeprom_req_info *request, |
| struct eeprom_reply_data *reply, |
| struct genl_info *info) |
| { |
| struct net_device *dev = reply->base.dev; |
| struct ethtool_modinfo modinfo = {0}; |
| struct ethtool_eeprom eeprom = {0}; |
| u8 *data; |
| int err; |
| |
| modinfo.cmd = ETHTOOL_GMODULEINFO; |
| err = ethtool_get_module_info_call(dev, &modinfo); |
| if (err < 0) |
| return err; |
| |
| err = fallback_set_params(request, &modinfo, &eeprom); |
| if (err < 0) |
| return err; |
| |
| data = kmalloc(eeprom.len, GFP_KERNEL); |
| if (!data) |
| return -ENOMEM; |
| err = ethtool_get_module_eeprom_call(dev, &eeprom, data); |
| if (err < 0) |
| goto err_out; |
| |
| reply->data = data; |
| reply->length = eeprom.len; |
| |
| return 0; |
| |
| err_out: |
| kfree(data); |
| return err; |
| } |
| |
| static int get_module_eeprom_by_page(struct net_device *dev, |
| struct ethtool_module_eeprom *page_data, |
| struct netlink_ext_ack *extack) |
| { |
| const struct ethtool_ops *ops = dev->ethtool_ops; |
| |
| if (dev->sfp_bus) |
| return sfp_get_module_eeprom_by_page(dev->sfp_bus, page_data, extack); |
| |
| if (ops->get_module_eeprom_by_page) |
| return ops->get_module_eeprom_by_page(dev, page_data, extack); |
| |
| return -EOPNOTSUPP; |
| } |
| |
| static int eeprom_prepare_data(const struct ethnl_req_info *req_base, |
| struct ethnl_reply_data *reply_base, |
| struct genl_info *info) |
| { |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); |
| struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_base); |
| struct ethtool_module_eeprom page_data = {0}; |
| struct net_device *dev = reply_base->dev; |
| int ret; |
| |
| page_data.offset = request->offset; |
| page_data.length = request->length; |
| page_data.i2c_address = request->i2c_address; |
| page_data.page = request->page; |
| page_data.bank = request->bank; |
| page_data.data = kmalloc(page_data.length, GFP_KERNEL); |
| if (!page_data.data) |
| return -ENOMEM; |
| |
| ret = ethnl_ops_begin(dev); |
| if (ret) |
| goto err_free; |
| |
| ret = get_module_eeprom_by_page(dev, &page_data, info ? info->extack : NULL); |
| if (ret < 0) |
| goto err_ops; |
| |
| reply->length = ret; |
| reply->data = page_data.data; |
| |
| ethnl_ops_complete(dev); |
| return 0; |
| |
| err_ops: |
| ethnl_ops_complete(dev); |
| err_free: |
| kfree(page_data.data); |
| |
| if (ret == -EOPNOTSUPP) |
| return eeprom_fallback(request, reply, info); |
| return ret; |
| } |
| |
| static int eeprom_parse_request(struct ethnl_req_info *req_info, struct nlattr **tb, |
| struct netlink_ext_ack *extack) |
| { |
| struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_info); |
| |
| if (!tb[ETHTOOL_A_MODULE_EEPROM_OFFSET] || |
| !tb[ETHTOOL_A_MODULE_EEPROM_LENGTH] || |
| !tb[ETHTOOL_A_MODULE_EEPROM_PAGE] || |
| !tb[ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS]) |
| return -EINVAL; |
| |
| request->i2c_address = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS]); |
| request->offset = nla_get_u32(tb[ETHTOOL_A_MODULE_EEPROM_OFFSET]); |
| request->length = nla_get_u32(tb[ETHTOOL_A_MODULE_EEPROM_LENGTH]); |
| |
| /* The following set of conditions limit the API to only dump 1/2 |
| * EEPROM page without crossing low page boundary located at offset 128. |
| * This means user may only request dumps of length limited to 128 from |
| * either low 128 bytes or high 128 bytes. |
| * For pages higher than 0 only high 128 bytes are accessible. |
| */ |
| request->page = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_PAGE]); |
| if (request->page && request->offset < ETH_MODULE_EEPROM_PAGE_LEN) { |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_PAGE], |
| "reading from lower half page is allowed for page 0 only"); |
| return -EINVAL; |
| } |
| |
| if (request->offset < ETH_MODULE_EEPROM_PAGE_LEN && |
| request->offset + request->length > ETH_MODULE_EEPROM_PAGE_LEN) { |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_LENGTH], |
| "reading cross half page boundary is illegal"); |
| return -EINVAL; |
| } else if (request->offset + request->length > ETH_MODULE_EEPROM_PAGE_LEN * 2) { |
| NL_SET_ERR_MSG_ATTR(extack, tb[ETHTOOL_A_MODULE_EEPROM_LENGTH], |
| "reading cross page boundary is illegal"); |
| return -EINVAL; |
| } |
| |
| if (tb[ETHTOOL_A_MODULE_EEPROM_BANK]) |
| request->bank = nla_get_u8(tb[ETHTOOL_A_MODULE_EEPROM_BANK]); |
| |
| return 0; |
| } |
| |
| static int eeprom_reply_size(const struct ethnl_req_info *req_base, |
| const struct ethnl_reply_data *reply_base) |
| { |
| const struct eeprom_req_info *request = MODULE_EEPROM_REQINFO(req_base); |
| |
| return nla_total_size(sizeof(u8) * request->length); /* _EEPROM_DATA */ |
| } |
| |
| static int eeprom_fill_reply(struct sk_buff *skb, |
| const struct ethnl_req_info *req_base, |
| const struct ethnl_reply_data *reply_base) |
| { |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); |
| |
| return nla_put(skb, ETHTOOL_A_MODULE_EEPROM_DATA, reply->length, reply->data); |
| } |
| |
| static void eeprom_cleanup_data(struct ethnl_reply_data *reply_base) |
| { |
| struct eeprom_reply_data *reply = MODULE_EEPROM_REPDATA(reply_base); |
| |
| kfree(reply->data); |
| } |
| |
| const struct ethnl_request_ops ethnl_module_eeprom_request_ops = { |
| .request_cmd = ETHTOOL_MSG_MODULE_EEPROM_GET, |
| .reply_cmd = ETHTOOL_MSG_MODULE_EEPROM_GET_REPLY, |
| .hdr_attr = ETHTOOL_A_MODULE_EEPROM_HEADER, |
| .req_info_size = sizeof(struct eeprom_req_info), |
| .reply_data_size = sizeof(struct eeprom_reply_data), |
| |
| .parse_request = eeprom_parse_request, |
| .prepare_data = eeprom_prepare_data, |
| .reply_size = eeprom_reply_size, |
| .fill_reply = eeprom_fill_reply, |
| .cleanup_data = eeprom_cleanup_data, |
| }; |
| |
| const struct nla_policy ethnl_module_eeprom_get_policy[] = { |
| [ETHTOOL_A_MODULE_EEPROM_HEADER] = NLA_POLICY_NESTED(ethnl_header_policy), |
| [ETHTOOL_A_MODULE_EEPROM_OFFSET] = |
| NLA_POLICY_MAX(NLA_U32, ETH_MODULE_EEPROM_PAGE_LEN * 2 - 1), |
| [ETHTOOL_A_MODULE_EEPROM_LENGTH] = |
| NLA_POLICY_RANGE(NLA_U32, 1, ETH_MODULE_EEPROM_PAGE_LEN), |
| [ETHTOOL_A_MODULE_EEPROM_PAGE] = { .type = NLA_U8 }, |
| [ETHTOOL_A_MODULE_EEPROM_BANK] = { .type = NLA_U8 }, |
| [ETHTOOL_A_MODULE_EEPROM_I2C_ADDRESS] = |
| NLA_POLICY_RANGE(NLA_U8, 0, ETH_MODULE_MAX_I2C_ADDRESS), |
| }; |
| |