| Texas Instuments SK-AM62A Test and Development Board |
| |
| Description |
| =========== |
| |
| This configuration will build a complete image for the TI SK-AM62A |
| board: https://www.ti.com/tool/SK-AM62A-LP |
| |
| How to Build |
| ============ |
| |
| Select the default configuration for the target: |
| |
| $ make ti_am62ax_sk_defconfig |
| |
| Optional: modify the configuration: |
| |
| $ make menuconfig |
| |
| IMPORTANT: make sure to use the tiboot3 firmware that match with the TI |
| K3 SoC boot ROM (tiboot3-am62ax-{gp/hs-fs/hs}-evm.bin) used on the board. |
| Use the BR2_TARGET_TI_K3_R5_LOADER_TIBOOT3_BIN to name which tiboot3.bin |
| security variant we want to use. |
| |
| Build: |
| |
| $ make |
| |
| To copy the resultimg output image file to an SD card use dd: |
| |
| $ dd if=output/images/sdcard.img of=/dev/sdX bs=1M |
| |
| How to Run |
| ========== |
| |
| Insert the SD card into the SK-AM62A board, and power it up through the |
| USB Type-C connector. The system should come up. You can use a |
| micro-USB cable to connect to the connector labeled UART to |
| communicate with the board. |
