| |
| Intel Galileo Gen 1/2 |
| |
| Intro |
| ============ |
| |
| These instructions apply to both the Intel Galileo Gen 1/2 development boards |
| based on the Intel Quark X1000. |
| |
| How to build |
| ============ |
| |
| Apply the defconfig for the Intel Galileo Gen 1/2 |
| |
| $ make galileo_defconfig |
| |
| Add any additional packages required and build. |
| |
| $ make |
| |
| The build process will create a SD card image and place it in output/images. |
| |
| $ ls -lh output/images/sdcard.img |
| -rw-r--r--. 1 foo foo 11M Nov 17 16:19 output/images/sdcard.img |
| |
| Write the image to an mSD card, insert into the Galileo and power on. |
| |
| $ dd if=output/images/sdcard.img of=/dev/mmcblk0; sync |
| |
| Accessing the console |
| ===================== |
| |
| During power-on the console will become available on the Galileo's ttyS1. This |
| may be accessed as follows. |
| |
| * Galileo Gen 1 |
| |
| http://clayskits.com/products/galileo-gen-1-serial-cable |
| |
| A USB to RS-232 to 3.5mm Jack cable is required. Connect to the 3.5mm |
| Jack next to the Ethernet Header. |
| |
| * Galileo Gen 2 |
| |
| http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm |
| |
| A FTDI TTL-232R-3V3 cable may be used to connect to the FTDI header |
| next to the Ethernet connector on the Galileo Gen 2. |
| |
| The console should now be visible at 115200 baud. |
| |
| $ picocom -b 115200 /dev/ttyUSB0 |
