| OMAP5432 uEVM |
| ============= |
| |
| This file documents the Buildroot support for the OMAP5432 uEVM[1], a |
| single-board computer development platform based on the Texas Instruments |
| OMAP5432 system on a chip (SoC). |
| |
| How to build |
| ============ |
| |
| $ make uevm5432_defconfig |
| $ make |
| |
| How to write the SD card |
| ======================== |
| |
| Once the build process is finished you will have an image called "sdcard.img" |
| in the output/images/ directory. |
| |
| Copy the bootable "sdcard.img" onto an SD card with "dd": |
| |
| $ sudo dd if=output/images/sdcard.img of=/dev/sdX |
| $ sync |
| |
| Where /dev/sdX is the device node of your SD card (may be /dev/mmcblkX instead |
| depending on setup). |
| |
| To boot from SD card, set the SYSBOOT switches S1 of your OMAP5432 uEVM to the |
| following position: |
| |
| ON x x |
| x x |
| 1 2 3 4 |
| |
| Insert the micro SDcard in your OMAP5432 uEVM, and power it up with the POWER |
| ON push button switch S3. The console is on the micro USB Debug UART, with |
| serial settings 115200 8N1. Refer also to the quick start guide[2]. |
| |
| [1]: https://svtronics.com/5432 |
| [2]: https://www.ti.com/lit/ug/swcu131/swcu131.pdf |
