| Technologic Systems TS-5x00 SBCs |
| ================================ |
| |
| This document explains how to set up a basic Buildroot system for the |
| Technologic Systems TS-5x00 serie of x86-based Single Board Computers. |
| |
| TS-5x00 Single Board Computers are based on the AMD Elan520 processor. For more |
| information please have a look at http://wiki.embeddedarm.com/wiki/#AMD |
| |
| The kernel configuration works for any AMD Elan520-based SBCs, but the support |
| is enhanced for the TS-5500 and TS-5400 models (on-board devices registration |
| and additional sysfs attributes under /sys/devices/platform/). |
| |
| To build the default configuration you only have to: |
| |
| $ make ts5500_defconfig |
| $ make |
| |
| You will need a Compact Flash card of sufficient size and the first or only |
| partition configured as Linux type, with the bootable flag. |
| |
| You can transfer the system on the partition then optionally resize it with: |
| |
| # dd if=output/images/rootfs.ext4 of=/dev/sdX1 |
| # resize2fs /dev/sdX1 |
| |
| Or you can just extract the root filesystem to the partition with: |
| |
| # mount /dev/sdX1 /mnt |
| # tar -pxf output/images/rootfs.tar -C /mnt |
| # umount /mnt |
| |
| To install the bootloader, you will need to copy the MBR: |
| |
| # cat output/images/syslinux/mbr.bin > /dev/sdX |
| |
| Then install SYSLINUX in the mounted partition: |
| |
| # mount /dev/sdX1 /mnt |
| # output/host/sbin/extlinux --install /mnt/boot/syslinux |
| # umount /mnt |
| |
| IMPORTANT: In order for the board to boot the Compact Flash with a recent |
| config, the BIOS must use Logical Block Addressing (LBA). You can do it by |
| choosing "Ide 0: AUTOCONFIG, LBA" under "IDE DRIVE GEOMETRY" in the "Basic CMOS |
| Configuration" screen. Also, don't forget to set the 'active' (or 'bootable') |
| flag on partition 1. For details about the CMOS setup, please see: |
| http://wiki.embeddedarm.com/wiki/TS-5500#System_BIOS_Setup_Screens |
| |
| Connect a terminal program to the rs232 connector marked "COM2" |
| with baudrate set to 115200, insert the Compact Flash card into the socket, |
| power up the board, and enjoy. |