| ******************************** |
| Xilinx ZCU106 board - ZynqMP SoC |
| ******************************** |
| |
| This document describes the Buildroot support for the ZCU106 board by |
| Xilinx, based on the Zynq UltraScale+ MPSoC (aka ZynqMP). It has been |
| tested with the EK-U1-ZCU106-ES2 pre-production board. |
| |
| How to build it |
| =============== |
| |
| Configure Buildroot: |
| |
| $ make zynqmp_zcu106_defconfig |
| |
| Compile everything and build the rootfs image: |
| |
| $ make |
| |
| Result of the build |
| ------------------- |
| |
| After building, you should get a tree like this: |
| |
| output/images/ |
| +-- atf-uboot.ub |
| +-- bl31.bin |
| +-- boot.bin |
| +-- boot.vfat |
| +-- Image |
| +-- rootfs.ext2 |
| +-- rootfs.ext4 -> rootfs.ext2 |
| +-- sdcard.img |
| +-- system.dtb -> zynqmp-zcu106-revA.dtb |
| +-- u-boot.bin |
| `-- zynqmp-zcu106-revA.dtb |
| |
| How to write the SD card |
| ======================== |
| |
| WARNING! This will destroy all the card content. Use with care! |
| |
| The sdcard.img file is a complete bootable image ready to be written |
| on the boot medium. To install it, simply copy the image to an SD |
| card: |
| |
| # dd if=output/images/sdcard.img of=/dev/sdX |
| |
| Where 'sdX' is the device node of the SD. |
| |
| Eject the SD card, insert it in the board, and power it up. |
