| RADXA ROCKPI-N8 |
| ================ |
| https://wiki.radxa.com/RockpiN8 |
| |
| Build: |
| ====== |
| $ make rock_pi_n8_defconfig |
| $ make |
| |
| Files created in output directory |
| ================================= |
| |
| output/images |
| . |
| ├── boot.vfat |
| ├── extlinux |
| ├── idbloader.img |
| ├── rk3288-rock-pi-n8.dtb |
| ├── rootfs.ext2 |
| ├── rootfs.ext4 -> rootfs.ext2 |
| ├── rootfs.tar |
| ├── sdcard.img |
| ├── u-boot.bin |
| ├── u-boot-dtb.bin |
| ├── u-boot-dtb.img |
| └── zImage |
| |
| Creating bootable SD card: |
| ========================== |
| |
| Simply invoke (as root) |
| |
| sudo dd if=output/images/sdcard.img of=/dev/sdX && sync |
| |
| Where X is your SD card device. |
| |
| Booting: |
| ======== |
| |
| Serial console: |
| --------------- |
| RockPi-N8 has a 40-pin GPIO header. The pin layout is as follows: |
| |
| pin 6: gnd |
| pin 8: tx |
| pin 10: rx |
| |
| Baudrate for this board is 115200. |
| |
| The boot order on rockpi-n8 is emmc, sd. If emmc contains a valid Image, the board |
| always boots from emmc. To boot from SD, erase emmc as per the guide: |
| |
| https://wiki.amarulasolutions.com/bsp/setup/rockchip/rk3399_emmc.html |
| |
| Login: |
| ------ |
| Enter 'root' as login user, and the prompt is ready. |
| |
| wiki link: |
| ---------- |
| https://wiki.amarulasolutions.com/bsp/rockchip/rk3288/rock-pi-n8.html |
