| PINE64 ROCKPro64 |
| ================ |
| https://www.pine64.org/rockpro64/ |
| |
| Build: |
| ====== |
| $ make rockpro64_defconfig |
| $ make |
| |
| Files created in output directory |
| ================================= |
| |
| output/images |
| |
| ├── bl31.elf |
| ├── boot.vfat |
| ├── extlinux |
| ├── idbloader.img |
| ├── Image |
| ├── rk3399-rockpro64.dtb |
| ├── rootfs.ext2 |
| ├── rootfs.ext4 -> rootfs.ext2 |
| ├── rootfs.tar |
| ├── sdcard.img |
| ├── u-boot.bin |
| └── u-boot.itb |
| |
| Creating bootable SD card: |
| ========================== |
| |
| Simply invoke (as root) |
| |
| sudo dd if=output/images/sdcard.img of=/dev/sdX && sync |
| |
| Where X is your SD card device. |
| |
| Booting: |
| ======== |
| RockPro64 has a 40-pin PI-2 GPIO Bus. |
| |
| Connect a jumper between pin 23 and pin 25 for SD card boot. |
| |
| Serial console: |
| --------------- |
| The pin layout for serial console on PI-2 GPIO Bus is as follows: |
| |
| pin 6: gnd |
| pin 8: tx |
| pin 10: rx |
| |
| Initially connect pin 6 and pin 8(transmit). Apply power to RockPro64, once the |
| power is on then connect pin 10(receive). |
| |
| Baudrate for this board is 1500000. |
| |
| Login: |
| ------ |
| Enter 'root' as login user, and the prompt is ready. |
| |
| https://wiki.amarulasolutions.com/bsp/rockchip/rk3399/rockpro64.html |
