| // SPDX-License-Identifier: (GPL-2.0+ OR MIT) |
| /* |
| * Google Villager board device tree source |
| * |
| * Copyright 2022 Google LLC. |
| */ |
| |
| #include "sc7280-herobrine.dtsi" |
| |
| /* |
| * ADDITIONS TO FIXED REGULATORS DEFINED IN PARENT DEVICE TREE FILES |
| * |
| * Sort order matches the order in the parent files (parents before children). |
| */ |
| |
| &pp3300_codec { |
| status = "okay"; |
| }; |
| |
| /* ADDITIONS TO NODES DEFINED IN PARENT DEVICE TREE FILES */ |
| |
| ap_tp_i2c: &i2c0 { |
| status = "okay"; |
| clock-frequency = <400000>; |
| |
| trackpad: trackpad@2c { |
| compatible = "hid-over-i2c"; |
| reg = <0x2c>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&tp_int_odl>; |
| |
| interrupt-parent = <&tlmm>; |
| interrupts = <7 IRQ_TYPE_EDGE_FALLING>; |
| |
| hid-descr-addr = <0x20>; |
| vdd-supply = <&pp3300_z1>; |
| |
| wakeup-source; |
| }; |
| }; |
| |
| ts_i2c: &i2c13 { |
| status = "okay"; |
| clock-frequency = <400000>; |
| |
| ap_ts: touchscreen@10 { |
| compatible = "elan,ekth6915"; |
| reg = <0x10>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ts_int_conn>, <&ts_rst_conn>; |
| |
| interrupt-parent = <&tlmm>; |
| interrupts = <55 IRQ_TYPE_LEVEL_LOW>; |
| |
| reset-gpios = <&tlmm 54 GPIO_ACTIVE_LOW>; |
| |
| vcc33-supply = <&ts_avdd>; |
| vccio-supply = <&ts_avccio>; |
| }; |
| }; |
| |
| &ap_sar_sensor_i2c { |
| status = "okay"; |
| }; |
| |
| &ap_sar_sensor0 { |
| status = "okay"; |
| }; |
| |
| &ap_sar_sensor1 { |
| status = "okay"; |
| }; |
| |
| &mdss_edp { |
| status = "okay"; |
| }; |
| |
| &mdss_edp_phy { |
| status = "okay"; |
| }; |
| |
| &pwmleds { |
| status = "okay"; |
| }; |
| |
| /* For eMMC */ |
| &sdhc_1 { |
| status = "okay"; |
| }; |
| |
| /* PINCTRL - ADDITIONS TO NODES IN PARENT DEVICE TREE FILES */ |
| |
| &ts_rst_conn { |
| bias-disable; |
| }; |
| |
| /* PINCTRL - BOARD-SPECIFIC */ |
| |
| /* |
| * Methodology for gpio-line-names: |
| * - If a pin goes to herobrine board and is named it gets that name. |
| * - If a pin goes to herobrine board and is not named, it gets no name. |
| * - If a pin is totally internal to Qcard then it gets Qcard name. |
| * - If a pin is not hooked up on Qcard, it gets no name. |
| */ |
| |
| &pm8350c_gpios { |
| gpio-line-names = "FLASH_STROBE_1", /* 1 */ |
| "AP_SUSPEND", |
| "PM8008_1_RST_N", |
| "", |
| "", |
| "", |
| "PMIC_EDP_BL_EN", |
| "PMIC_EDP_BL_PWM", |
| ""; |
| }; |
| |
| &tlmm { |
| gpio-line-names = "AP_TP_I2C_SDA", /* 0 */ |
| "AP_TP_I2C_SCL", |
| "SSD_RST_L", |
| "PE_WAKE_ODL", |
| "AP_SAR_SDA", |
| "AP_SAR_SCL", |
| "PRB_SC_GPIO_6", |
| "TP_INT_ODL", |
| "HP_I2C_SDA", |
| "HP_I2C_SCL", |
| |
| "GNSS_L1_EN", /* 10 */ |
| "GNSS_L5_EN", |
| "SPI_AP_MOSI", |
| "SPI_AP_MISO", |
| "SPI_AP_CLK", |
| "SPI_AP_CS0_L", |
| /* |
| * AP_FLASH_WP is crossystem ABI. Schematics |
| * call it BIOS_FLASH_WP_OD. |
| */ |
| "AP_FLASH_WP", |
| "", |
| "AP_EC_INT_L", |
| "", |
| |
| "UF_CAM_RST_L", /* 20 */ |
| "WF_CAM_RST_L", |
| "UART_AP_TX_DBG_RX", |
| "UART_DBG_TX_AP_RX", |
| "", |
| "PM8008_IRQ_1", |
| "HOST2WLAN_SOL", |
| "WLAN2HOST_SOL", |
| "MOS_BT_UART_CTS", |
| "MOS_BT_UART_RFR", |
| |
| "MOS_BT_UART_TX", /* 30 */ |
| "MOS_BT_UART_RX", |
| "PRB_SC_GPIO_32", |
| "HUB_RST_L", |
| "", |
| "", |
| "AP_SPI_FP_MISO", |
| "AP_SPI_FP_MOSI", |
| "AP_SPI_FP_CLK", |
| "AP_SPI_FP_CS_L", |
| |
| "AP_EC_SPI_MISO", /* 40 */ |
| "AP_EC_SPI_MOSI", |
| "AP_EC_SPI_CLK", |
| "AP_EC_SPI_CS_L", |
| "LCM_RST_L", |
| "EARLY_EUD_N", |
| "", |
| "DP_HOT_PLUG_DET", |
| "IO_BRD_MLB_ID0", |
| "IO_BRD_MLB_ID1", |
| |
| "IO_BRD_MLB_ID2", /* 50 */ |
| "SSD_EN", |
| "TS_I2C_SDA_CONN", |
| "TS_I2C_CLK_CONN", |
| "TS_RST_CONN", |
| "TS_INT_CONN", |
| "AP_I2C_TPM_SDA", |
| "AP_I2C_TPM_SCL", |
| "PRB_SC_GPIO_58", |
| "PRB_SC_GPIO_59", |
| |
| "EDP_HOT_PLUG_DET_N", /* 60 */ |
| "FP_TO_AP_IRQ_L", |
| "", |
| "AMP_EN", |
| "CAM0_MCLK_GPIO_64", |
| "CAM1_MCLK_GPIO_65", |
| "WF_CAM_MCLK", |
| "PRB_SC_GPIO_67", |
| "FPMCU_BOOT0", |
| "UF_CAM_SDA", |
| |
| "UF_CAM_SCL", /* 70 */ |
| "", |
| "", |
| "WF_CAM_SDA", |
| "WF_CAM_SCL", |
| "", |
| "", |
| "EN_FP_RAILS", |
| "FP_RST_L", |
| "PCIE1_CLKREQ_ODL", |
| |
| "EN_PP3300_DX_EDP", /* 80 */ |
| "SC_GPIO_81", |
| "FORCED_USB_BOOT", |
| "WCD_RESET_N", |
| "MOS_WLAN_EN", |
| "MOS_BT_EN", |
| "MOS_SW_CTRL", |
| "MOS_PCIE0_RST", |
| "MOS_PCIE0_CLKREQ_N", |
| "MOS_PCIE0_WAKE_N", |
| |
| "MOS_LAA_AS_EN", /* 90 */ |
| "SD_CD_ODL", |
| "", |
| "", |
| "MOS_BT_WLAN_SLIMBUS_CLK", |
| "MOS_BT_WLAN_SLIMBUS_DAT0", |
| "HP_MCLK", |
| "HP_BCLK", |
| "HP_DOUT", |
| "HP_DIN", |
| |
| "HP_LRCLK", /* 100 */ |
| "HP_IRQ", |
| "", |
| "", |
| "GSC_AP_INT_ODL", |
| "EN_PP3300_CODEC", |
| "AMP_BCLK", |
| "AMP_DIN", |
| "AMP_LRCLK", |
| "UIM1_DATA_GPIO_109", |
| |
| "UIM1_CLK_GPIO_110", /* 110 */ |
| "UIM1_RESET_GPIO_111", |
| "PRB_SC_GPIO_112", |
| "UIM0_DATA", |
| "UIM0_CLK", |
| "UIM0_RST", |
| "UIM0_PRESENT_ODL", |
| "SDM_RFFE0_CLK", |
| "SDM_RFFE0_DATA", |
| "WF_CAM_EN", |
| |
| "FASTBOOT_SEL_0", /* 120 */ |
| "SC_GPIO_121", |
| "FASTBOOT_SEL_1", |
| "SC_GPIO_123", |
| "FASTBOOT_SEL_2", |
| "SM_RFFE4_CLK_GRFC_8", |
| "SM_RFFE4_DATA_GRFC_9", |
| "WLAN_COEX_UART1_RX", |
| "WLAN_COEX_UART1_TX", |
| "PRB_SC_GPIO_129", |
| |
| "LCM_ID0", /* 130 */ |
| "LCM_ID1", |
| "", |
| "SDR_QLINK_REQ", |
| "SDR_QLINK_EN", |
| "QLINK0_WMSS_RESET_N", |
| "SMR526_QLINK1_REQ", |
| "SMR526_QLINK1_EN", |
| "SMR526_QLINK1_WMSS_RESET_N", |
| "PRB_SC_GPIO_139", |
| |
| "SAR1_IRQ_ODL", /* 140 */ |
| "SAR0_IRQ_ODL", |
| "PRB_SC_GPIO_142", |
| "", |
| "WCD_SWR_TX_CLK", |
| "WCD_SWR_TX_DATA0", |
| "WCD_SWR_TX_DATA1", |
| "WCD_SWR_RX_CLK", |
| "WCD_SWR_RX_DATA0", |
| "WCD_SWR_RX_DATA1", |
| |
| "DMIC01_CLK", /* 150 */ |
| "DMIC01_DATA", |
| "DMIC23_CLK", |
| "DMIC23_DATA", |
| "", |
| "", |
| "EC_IN_RW_ODL", |
| "HUB_EN", |
| "WCD_SWR_TX_DATA2", |
| "", |
| |
| "", /* 160 */ |
| "", |
| "", |
| "", |
| "", |
| "", |
| "", |
| "", |
| "", |
| "", |
| |
| "", /* 170 */ |
| "MOS_BLE_UART_TX", |
| "MOS_BLE_UART_RX", |
| "", |
| ""; |
| }; |
