| # SPDX-License-Identifier: GPL-2.0-only |
| # |
| # Davicom device configuration |
| # |
| |
| config NET_VENDOR_DAVICOM |
| bool "Davicom devices" |
| default y |
| help |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Davicom devices. If you say Y, you will be asked |
| for your specific card in the following selections. |
| |
| if NET_VENDOR_DAVICOM |
| |
| config DM9000 |
| tristate "DM9000 support" |
| depends on ARM || MIPS || COLDFIRE || NIOS2 || COMPILE_TEST |
| select CRC32 |
| select MII |
| help |
| Support for DM9000 chipset. |
| |
| To compile this driver as a module, choose M here. The module |
| will be called dm9000. |
| |
| config DM9000_FORCE_SIMPLE_PHY_POLL |
| bool "Force simple NSR based PHY polling" |
| depends on DM9000 |
| help |
| This configuration forces the DM9000 to use the NSR's LinkStatus |
| bit to determine if the link is up or down instead of the more |
| costly MII PHY reads. Note, this will not work if the chip is |
| operating with an external PHY. |
| |
| config DM9051 |
| tristate "DM9051 SPI support" |
| depends on SPI |
| select CRC32 |
| select MDIO |
| select PHYLIB |
| select REGMAP_SPI |
| help |
| Support for DM9051 SPI chipset. |
| |
| To compile this driver as a module, choose M here. The module |
| will be called dm9051. |
| |
| The SPI mode for the host's SPI master to access DM9051 is mode |
| 0 on the SPI bus. |
| |
| endif # NET_VENDOR_DAVICOM |
