| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright 2019 NXP |
| */ |
| |
| #include <linux/clk.h> |
| #include <linux/devfreq.h> |
| #include <linux/device.h> |
| #include <linux/module.h> |
| #include <linux/of_device.h> |
| #include <linux/pm_opp.h> |
| #include <linux/platform_device.h> |
| #include <linux/slab.h> |
| |
| struct imx_bus { |
| struct devfreq_dev_profile profile; |
| struct devfreq *devfreq; |
| struct clk *clk; |
| struct platform_device *icc_pdev; |
| }; |
| |
| static int imx_bus_target(struct device *dev, |
| unsigned long *freq, u32 flags) |
| { |
| struct dev_pm_opp *new_opp; |
| int ret; |
| |
| new_opp = devfreq_recommended_opp(dev, freq, flags); |
| if (IS_ERR(new_opp)) { |
| ret = PTR_ERR(new_opp); |
| dev_err(dev, "failed to get recommended opp: %d\n", ret); |
| return ret; |
| } |
| dev_pm_opp_put(new_opp); |
| |
| return dev_pm_opp_set_rate(dev, *freq); |
| } |
| |
| static int imx_bus_get_cur_freq(struct device *dev, unsigned long *freq) |
| { |
| struct imx_bus *priv = dev_get_drvdata(dev); |
| |
| *freq = clk_get_rate(priv->clk); |
| |
| return 0; |
| } |
| |
| static int imx_bus_get_dev_status(struct device *dev, |
| struct devfreq_dev_status *stat) |
| { |
| struct imx_bus *priv = dev_get_drvdata(dev); |
| |
| stat->busy_time = 0; |
| stat->total_time = 0; |
| stat->current_frequency = clk_get_rate(priv->clk); |
| |
| return 0; |
| } |
| |
| static void imx_bus_exit(struct device *dev) |
| { |
| struct imx_bus *priv = dev_get_drvdata(dev); |
| |
| dev_pm_opp_of_remove_table(dev); |
| platform_device_unregister(priv->icc_pdev); |
| } |
| |
| /* imx_bus_init_icc() - register matching icc provider if required */ |
| static int imx_bus_init_icc(struct device *dev) |
| { |
| struct imx_bus *priv = dev_get_drvdata(dev); |
| const char *icc_driver_name; |
| |
| if (!of_get_property(dev->of_node, "#interconnect-cells", 0)) |
| return 0; |
| if (!IS_ENABLED(CONFIG_INTERCONNECT_IMX)) { |
| dev_warn(dev, "imx interconnect drivers disabled\n"); |
| return 0; |
| } |
| |
| icc_driver_name = of_device_get_match_data(dev); |
| if (!icc_driver_name) { |
| dev_err(dev, "unknown interconnect driver\n"); |
| return 0; |
| } |
| |
| priv->icc_pdev = platform_device_register_data( |
| dev, icc_driver_name, -1, NULL, 0); |
| if (IS_ERR(priv->icc_pdev)) { |
| dev_err(dev, "failed to register icc provider %s: %ld\n", |
| icc_driver_name, PTR_ERR(priv->icc_pdev)); |
| return PTR_ERR(priv->icc_pdev); |
| } |
| |
| return 0; |
| } |
| |
| static int imx_bus_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct imx_bus *priv; |
| const char *gov = DEVFREQ_GOV_USERSPACE; |
| int ret; |
| |
| priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| /* |
| * Fetch the clock to adjust but don't explicitly enable. |
| * |
| * For imx bus clock clk_set_rate is safe no matter if the clock is on |
| * or off and some peripheral side-buses might be off unless enabled by |
| * drivers for devices on those specific buses. |
| * |
| * Rate adjustment on a disabled bus clock just takes effect later. |
| */ |
| priv->clk = devm_clk_get(dev, NULL); |
| if (IS_ERR(priv->clk)) { |
| ret = PTR_ERR(priv->clk); |
| dev_err(dev, "failed to fetch clk: %d\n", ret); |
| return ret; |
| } |
| platform_set_drvdata(pdev, priv); |
| |
| ret = dev_pm_opp_of_add_table(dev); |
| if (ret < 0) { |
| dev_err(dev, "failed to get OPP table\n"); |
| return ret; |
| } |
| |
| priv->profile.polling_ms = 1000; |
| priv->profile.target = imx_bus_target; |
| priv->profile.get_dev_status = imx_bus_get_dev_status; |
| priv->profile.exit = imx_bus_exit; |
| priv->profile.get_cur_freq = imx_bus_get_cur_freq; |
| priv->profile.initial_freq = clk_get_rate(priv->clk); |
| |
| priv->devfreq = devm_devfreq_add_device(dev, &priv->profile, |
| gov, NULL); |
| if (IS_ERR(priv->devfreq)) { |
| ret = PTR_ERR(priv->devfreq); |
| dev_err(dev, "failed to add devfreq device: %d\n", ret); |
| goto err; |
| } |
| |
| ret = imx_bus_init_icc(dev); |
| if (ret) |
| goto err; |
| |
| return 0; |
| |
| err: |
| dev_pm_opp_of_remove_table(dev); |
| return ret; |
| } |
| |
| static const struct of_device_id imx_bus_of_match[] = { |
| { .compatible = "fsl,imx8mq-noc", .data = "imx8mq-interconnect", }, |
| { .compatible = "fsl,imx8mm-noc", .data = "imx8mm-interconnect", }, |
| { .compatible = "fsl,imx8mn-noc", .data = "imx8mn-interconnect", }, |
| { .compatible = "fsl,imx8m-noc", }, |
| { .compatible = "fsl,imx8m-nic", }, |
| { /* sentinel */ }, |
| }; |
| MODULE_DEVICE_TABLE(of, imx_bus_of_match); |
| |
| static struct platform_driver imx_bus_platdrv = { |
| .probe = imx_bus_probe, |
| .driver = { |
| .name = "imx-bus-devfreq", |
| .of_match_table = imx_bus_of_match, |
| }, |
| }; |
| module_platform_driver(imx_bus_platdrv); |
| |
| MODULE_DESCRIPTION("Generic i.MX bus frequency scaling driver"); |
| MODULE_AUTHOR("Leonard Crestez <leonard.crestez@nxp.com>"); |
| MODULE_LICENSE("GPL v2"); |