blob: 062ebb14cecfa713ecbba88ca290b18742c0239c [file] [log] [blame]
TI Real Time Clock
Required properties:
- compatible:
- "ti,da830-rtc" - for RTC IP used similar to that on DA8xx SoC family.
- "ti,am3352-rtc" - for RTC IP used similar to that on AM335x SoC family.
This RTC IP has special WAKE-EN Register to enable
Wakeup generation for event Alarm. It can also be
used to control an external PMIC via the
pmic_power_en pin.
- "ti,am4372-rtc" - for RTC IP used similar to that on AM437X SoC family.
- reg: Address range of rtc register set
- interrupts: rtc timer, alarm interrupts in order
Optional properties:
- system-power-controller: whether the rtc is controlling the system power
through pmic_power_en
- clocks: Any internal or external clocks feeding in to rtc
- clock-names: Corresponding names of the clocks
- pinctrl-0: a phandle pointing to the pin settings for the device
- pinctrl-names: should be "default"
Optional subnodes:
- generic pinctrl node
Required pinctrl subnodes properties:
- pins - Names of ext_wakeup pins to configure
Optional pinctrl subnodes properties:
- input-enable - Enables ext_wakeup
- ti,active-high - Set input active high (by default active low)
rtc@1c23000 {
compatible = "ti,da830-rtc";
reg = <0x23000 0x1000>;
interrupts = <19
interrupt-parent = <&intc>;
clocks = <&clk_32k_rtc>, <&clk_32768_ck>;
clock-names = "ext-clk", "int-clk";
pinctrl-0 = <&ext_wakeup>;
pinctrl-names = "default";
ext_wakeup: ext-wakeup {
pins = "ext_wakeup0";