blob: 0e7087cc8bf95ea10fe40bf5364a0412b610ece7 [file] [log] [blame]
# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/spi/cdns,qspi-nor.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: Cadence Quad SPI controller
maintainers:
- Pratyush Yadav <p.yadav@ti.com>
allOf:
- $ref: spi-controller.yaml#
properties:
compatible:
oneOf:
- items:
- enum:
- ti,k2g-qspi
- ti,am654-ospi
- intel,lgm-qspi
- const: cdns,qspi-nor
- const: cdns,qspi-nor
reg:
items:
- description: the controller register set
- description: the controller data area
interrupts:
maxItems: 1
clocks:
maxItems: 1
cdns,fifo-depth:
description:
Size of the data FIFO in words.
$ref: "/schemas/types.yaml#/definitions/uint32"
enum: [ 128, 256 ]
default: 128
cdns,fifo-width:
$ref: /schemas/types.yaml#/definitions/uint32
description:
Bus width of the data FIFO in bytes.
default: 4
cdns,trigger-address:
$ref: /schemas/types.yaml#/definitions/uint32
description:
32-bit indirect AHB trigger address.
cdns,is-decoded-cs:
type: boolean
description:
Flag to indicate whether decoder is used to select different chip select
for different memory regions.
cdns,rclk-en:
type: boolean
description:
Flag to indicate that QSPI return clock is used to latch the read
data rather than the QSPI clock. Make sure that QSPI return clock
is populated on the board before using this property.
resets:
maxItems: 2
reset-names:
minItems: 1
maxItems: 2
items:
enum: [ qspi, qspi-ocp ]
# subnode's properties
patternProperties:
"@[0-9a-f]+$":
type: object
description:
Flash device uses the below defined properties in the subnode.
properties:
cdns,read-delay:
$ref: /schemas/types.yaml#/definitions/uint32
description:
Delay for read capture logic, in clock cycles.
cdns,tshsl-ns:
description:
Delay in nanoseconds for the length that the master mode chip select
outputs are de-asserted between transactions.
cdns,tsd2d-ns:
description:
Delay in nanoseconds between one chip select being de-activated
and the activation of another.
cdns,tchsh-ns:
description:
Delay in nanoseconds between last bit of current transaction and
deasserting the device chip select (qspi_n_ss_out).
cdns,tslch-ns:
description:
Delay in nanoseconds between setting qspi_n_ss_out low and
first bit transfer.
required:
- compatible
- reg
- interrupts
- clocks
- cdns,fifo-depth
- cdns,fifo-width
- cdns,trigger-address
- '#address-cells'
- '#size-cells'
unevaluatedProperties: false
examples:
- |
qspi: spi@ff705000 {
compatible = "cdns,qspi-nor";
#address-cells = <1>;
#size-cells = <0>;
reg = <0xff705000 0x1000>,
<0xffa00000 0x1000>;
interrupts = <0 151 4>;
clocks = <&qspi_clk>;
cdns,fifo-depth = <128>;
cdns,fifo-width = <4>;
cdns,trigger-address = <0x00000000>;
resets = <&rst 0x1>, <&rst 0x2>;
reset-names = "qspi", "qspi-ocp";
flash@0 {
compatible = "jedec,spi-nor";
reg = <0x0>;
};
};