| * AB8500 Multi-Functional Device (MFD) |
| |
| Required parent device properties: |
| - compatible : contains "stericsson,ab8500"; |
| - interrupts : contains the IRQ line for the AB8500 |
| - interrupt-controller : describes the AB8500 as an Interrupt Controller (has its own domain) |
| - #interrupt-cells : should be 2, for 2-cell format |
| - The first cell is the AB8500 local IRQ number |
| - The second cell is used to specify optional parameters |
| - bits[3:0] trigger type and level flags: |
| 1 = low-to-high edge triggered |
| 2 = high-to-low edge triggered |
| 4 = active high level-sensitive |
| 8 = active low level-sensitive |
| |
| The AB8500 consists of a large and varied group of sub-devices: |
| |
| Device IRQ Names Supply Names Description |
| ------ --------- ------------ ----------- |
| ab8500-bm : : : Battery Manager |
| ab8500-btemp : : : Battery Temperature |
| ab8500-charger : : : Battery Charger |
| ab8500-codec : : : Audio Codec |
| ab8500-fg : : vddadc : Fuel Gauge |
| : NCONV_ACCU : : Accumulate N Sample Conversion |
| : BATT_OVV : : Battery Over Voltage |
| : LOW_BAT_F : : LOW threshold battery voltage |
| : CC_INT_CALIB : : Coulomb Counter Internal Calibration |
| : CCEOC : : Coulomb Counter End of Conversion |
| ab8500-btemp : : vtvout : Battery Temperature |
| : BAT_CTRL_INDB : : Battery Removal Indicator |
| : BTEMP_LOW : : Btemp < BtempLow, if battery temperature is lower than -10°C |
| : BTEMP_LOW_MEDIUM : : BtempLow < Btemp < BtempMedium,if battery temperature is between -10 and 0°C |
| : BTEMP_MEDIUM_HIGH : : BtempMedium < Btemp < BtempHigh,if battery temperature is between 0°C and“MaxTemp |
| : BTEMP_HIGH : : Btemp > BtempHigh, if battery temperature is higher than “MaxTemp |
| ab8500-charger : : vddadc : Charger interface |
| : MAIN_CH_UNPLUG_DET : : main charger unplug detection management (not in 8505) |
| : MAIN_CHARGE_PLUG_DET : : main charger plug detection management (not in 8505) |
| : MAIN_EXT_CH_NOT_OK : : main charger not OK |
| : MAIN_CH_TH_PROT_R : : Die temp is above main charger |
| : MAIN_CH_TH_PROT_F : : Die temp is below main charger |
| : VBUS_DET_F : : VBUS falling detected |
| : VBUS_DET_R : : VBUS rising detected |
| : USB_LINK_STATUS : : USB link status has changed |
| : USB_CH_TH_PROT_R : : Die temp is above usb charger |
| : USB_CH_TH_PROT_F : : Die temp is below usb charger |
| : USB_CHARGER_NOT_OKR : : allowed USB charger not ok detection |
| : VBUS_OVV : : Overvoltage on Vbus ball detected (USB charge is stopped) |
| : CH_WD_EXP : : Charger watchdog detected |
| ab8500-gpadc : HW_CONV_END : vddadc : Analogue to Digital Converter |
| SW_CONV_END : : |
| ab8500-gpio : : : GPIO Controller |
| ab8500-ponkey : ONKEY_DBF : : Power-on Key |
| ONKEY_DBR : : |
| ab8500-pwm : : : Pulse Width Modulator |
| ab8500-regulator : : : Regulators |
| ab8500-rtc : 60S : : Real Time Clock |
| : ALARM : : |
| ab8500-sysctrl : : : System Control |
| ab8500-usb : ID_WAKEUP_R : vddulpivio18 : Universal Serial Bus |
| : ID_WAKEUP_F : v-ape : |
| : VBUS_DET_F : musb_1v8 : |
| : VBUS_DET_R : : |
| : USB_LINK_STATUS : : |
| : USB_ADP_PROBE_PLUG : : |
| : USB_ADP_PROBE_UNPLUG : : |
| |
| Required child device properties: |
| - compatible : "stericsson,ab8500-[bm|btemp|charger|fg|gpadc|gpio|ponkey| |
| pwm|regulator|rtc|sysctrl|usb]"; |
| |
| Optional child device properties: |
| - interrupts : contains the device IRQ(s) using the 2-cell format (see above) |
| - interrupt-names : contains names of IRQ resource in the order in which they were |
| supplied in the interrupts property |
| - <supply_name>-supply : contains a phandle to the regulator supply node in Device Tree |
| |
| Non-standard child device properties: |
| - Audio CODEC: |
| - stericsson,amic[1|2]-type-single-ended : Single-ended Analoge Mic (default: differential) |
| - stericsson,amic1a-bias-vamic2 : Analoge Mic wishes to use a non-standard Vamic |
| - stericsson,amic1b-bias-vamic2 : Analoge Mic wishes to use a non-standard Vamic |
| - stericsson,amic2-bias-vamic1 : Analoge Mic wishes to use a non-standard Vamic |
| - stericsson,earpeice-cmv : Earpeice voltage (only: 950 | 1100 | 1270 | 1580) |
| |
| ab8500 { |
| compatible = "stericsson,ab8500"; |
| interrupts = <0 40 0x4>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| |
| ab8500-rtc { |
| compatible = "stericsson,ab8500-rtc"; |
| interrupts = <17 0x4 |
| 18 0x4>; |
| interrupt-names = "60S", "ALARM"; |
| }; |
| |
| ab8500-gpadc { |
| compatible = "stericsson,ab8500-gpadc"; |
| interrupts = <32 0x4 |
| 39 0x4>; |
| interrupt-names = "HW_CONV_END", "SW_CONV_END"; |
| vddadc-supply = <&ab8500_ldo_tvout_reg>; |
| }; |
| |
| ab8500-usb { |
| compatible = "stericsson,ab8500-usb"; |
| interrupts = < 90 0x4 |
| 96 0x4 |
| 14 0x4 |
| 15 0x4 |
| 79 0x4 |
| 74 0x4 |
| 75 0x4>; |
| interrupt-names = "ID_WAKEUP_R", |
| "ID_WAKEUP_F", |
| "VBUS_DET_F", |
| "VBUS_DET_R", |
| "USB_LINK_STATUS", |
| "USB_ADP_PROBE_PLUG", |
| "USB_ADP_PROBE_UNPLUG"; |
| vddulpivio18-supply = <&ab8500_ldo_initcore_reg>; |
| v-ape-supply = <&db8500_vape_reg>; |
| musb_1v8-supply = <&db8500_vsmps2_reg>; |
| }; |
| |
| ab8500-ponkey { |
| compatible = "stericsson,ab8500-ponkey"; |
| interrupts = <6 0x4 |
| 7 0x4>; |
| interrupt-names = "ONKEY_DBF", "ONKEY_DBR"; |
| }; |
| |
| ab8500-sysctrl { |
| compatible = "stericsson,ab8500-sysctrl"; |
| }; |
| |
| ab8500-pwm { |
| compatible = "stericsson,ab8500-pwm"; |
| }; |
| |
| codec: ab8500-codec { |
| compatible = "stericsson,ab8500-codec"; |
| |
| stericsson,earpeice-cmv = <950>; /* Units in mV. */ |
| }; |
| |
| ab8500-regulators { |
| compatible = "stericsson,ab8500-regulator"; |
| |
| ab8500_ldo_aux1_reg: ab8500_ldo_aux1 { |
| /* |
| * See: Documentation/devicetree/bindings/regulator/regulator.txt |
| * for more information on regulators |
| */ |
| }; |
| }; |
| }; |
