blob: aca0052a02b75d272afd719eb4b32993fd99250c [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
#include <dt-bindings/iio/qcom,spmi-vadc.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
/ {
thermal-zones {
pm8941-thermal {
polling-delay-passive = <100>;
polling-delay = <0>;
thermal-sensors = <&pm8941_temp>;
trips {
trip0 {
temperature = <105000>;
hysteresis = <2000>;
type = "passive";
};
trip1 {
temperature = <125000>;
hysteresis = <2000>;
type = "hot";
};
crit {
temperature = <145000>;
hysteresis = <2000>;
type = "critical";
};
};
};
};
};
&spmi_bus {
pm8941_0: pm8941@0 {
compatible = "qcom,pm8941", "qcom,spmi-pmic";
reg = <0x0 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
rtc@6000 {
compatible = "qcom,pm8941-rtc";
reg = <0x6000>,
<0x6100>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
};
pon@800 {
compatible = "qcom,pm8941-pon";
reg = <0x800>;
pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
};
pm8941_resin: resin {
compatible = "qcom,pm8941-resin";
interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
status = "disabled";
};
};
usb_id: usb-detect@900 {
compatible = "qcom,pm8941-misc";
reg = <0x900>;
interrupts = <0x0 0x9 0 IRQ_TYPE_EDGE_BOTH>;
interrupt-names = "usb_id";
};
smbb: charger@1000 {
compatible = "qcom,pm8941-charger";
reg = <0x1000>;
interrupts = <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x10 5 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x10 4 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x12 1 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x12 0 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x13 2 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x14 1 IRQ_TYPE_EDGE_BOTH>;
interrupt-names = "chg-done",
"chg-fast",
"chg-trkl",
"bat-temp-ok",
"bat-present",
"chg-gone",
"usb-valid",
"dc-valid";
usb-otg-in-supply = <&pm8941_5vs1>;
status = "disabled";
chg_otg: otg-vbus { };
};
pm8941_gpios: gpio@c000 {
compatible = "qcom,pm8941-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pm8941_gpios 0 0 36>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
boost_bypass_n_pin: boost-bypass-state {
pins = "gpio21";
function = "normal";
};
};
pm8941_mpps: mpps@a000 {
compatible = "qcom,pm8941-mpp", "qcom,spmi-mpp";
reg = <0xa000>;
gpio-controller;
#gpio-cells = <2>;
gpio-ranges = <&pm8941_mpps 0 0 8>;
interrupt-controller;
#interrupt-cells = <2>;
};
pm8941_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
io-channels = <&pm8941_vadc VADC_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pm8941_vadc: adc@3100 {
compatible = "qcom,spmi-vadc";
reg = <0x3100>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
channel@6 {
reg = <VADC_VBAT_SNS>;
};
channel@8 {
reg = <VADC_DIE_TEMP>;
};
channel@9 {
reg = <VADC_REF_625MV>;
};
channel@a {
reg = <VADC_REF_1250MV>;
};
channel@e {
reg = <VADC_GND_REF>;
};
channel@f {
reg = <VADC_VDD_VADC>;
};
channel@30 {
reg = <VADC_LR_MUX1_BAT_THERM>;
};
};
pm8941_iadc: adc@3600 {
compatible = "qcom,pm8941-iadc", "qcom,spmi-iadc";
reg = <0x3600>;
interrupts = <0x0 0x36 0x0 IRQ_TYPE_EDGE_RISING>;
qcom,external-resistor-micro-ohms = <10000>;
};
pm8941_coincell: charger@2800 {
compatible = "qcom,pm8941-coincell";
reg = <0x2800>;
status = "disabled";
};
};
pm8941_1: pm8941@1 {
compatible = "qcom,pm8941", "qcom,spmi-pmic";
reg = <0x1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pm8941_lpg: pwm {
compatible = "qcom,pm8941-lpg";
#address-cells = <1>;
#size-cells = <0>;
#pwm-cells = <2>;
status = "disabled";
};
pm8941_vib: vibrator@c000 {
compatible = "qcom,pm8916-vib";
reg = <0xc000>;
status = "disabled";
};
pm8941_wled: wled@d800 {
compatible = "qcom,pm8941-wled";
reg = <0xd800>;
label = "backlight";
status = "disabled";
};
regulators {
compatible = "qcom,pm8941-regulators";
interrupts = <0x1 0x83 0x2 0>, <0x1 0x84 0x2 0>;
interrupt-names = "ocp-5vs1", "ocp-5vs2";
vin_5vs-supply = <&pm8941_5v>;
pm8941_5v: s4 {
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
regulator-enable-ramp-delay = <500>;
};
pm8941_5vs1: 5vs1 {
regulator-enable-ramp-delay = <1000>;
regulator-pull-down;
regulator-over-current-protection;
qcom,ocp-max-retries = <10>;
qcom,ocp-retry-delay = <30>;
qcom,vs-soft-start-strength = <0>;
regulator-initial-mode = <1>;
};
pm8941_5vs2: 5vs2 {
regulator-enable-ramp-delay = <1000>;
regulator-pull-down;
regulator-over-current-protection;
qcom,ocp-max-retries = <10>;
qcom,ocp-retry-delay = <30>;
qcom,vs-soft-start-strength = <0>;
regulator-initial-mode = <1>;
};
};
};
};