| /* SPDX-License-Identifier: GPL-2.0-only */ |
| /**************************************************************************** |
| * Driver for Solarflare network controllers and boards |
| * Copyright 2010-2012 Solarflare Communications Inc. |
| */ |
| #ifndef _VFDI_H |
| #define _VFDI_H |
| |
| /** |
| * DOC: Virtual Function Driver Interface |
| * |
| * This file contains software structures used to form a two way |
| * communication channel between the VF driver and the PF driver, |
| * named Virtual Function Driver Interface (VFDI). |
| * |
| * For the purposes of VFDI, a page is a memory region with size and |
| * alignment of 4K. All addresses are DMA addresses to be used within |
| * the domain of the relevant VF. |
| * |
| * The only hardware-defined channels for a VF driver to communicate |
| * with the PF driver are the event mailboxes (%FR_CZ_USR_EV |
| * registers). Writing to these registers generates an event with |
| * EV_CODE = EV_CODE_USR_EV, USER_QID set to the index of the mailbox |
| * and USER_EV_REG_VALUE set to the value written. The PF driver may |
| * direct or disable delivery of these events by setting |
| * %FR_CZ_USR_EV_CFG. |
| * |
| * The PF driver can send arbitrary events to arbitrary event queues. |
| * However, for consistency, VFDI events from the PF are defined to |
| * follow the same form and be sent to the first event queue assigned |
| * to the VF while that queue is enabled by the VF driver. |
| * |
| * The general form of the variable bits of VFDI events is: |
| * |
| * 0 16 24 31 |
| * | DATA | TYPE | SEQ | |
| * |
| * SEQ is a sequence number which should be incremented by 1 (modulo |
| * 256) for each event. The sequence numbers used in each direction |
| * are independent. |
| * |
| * The VF submits requests of type &struct vfdi_req by sending the |
| * address of the request (ADDR) in a series of 4 events: |
| * |
| * 0 16 24 31 |
| * | ADDR[0:15] | VFDI_EV_TYPE_REQ_WORD0 | SEQ | |
| * | ADDR[16:31] | VFDI_EV_TYPE_REQ_WORD1 | SEQ+1 | |
| * | ADDR[32:47] | VFDI_EV_TYPE_REQ_WORD2 | SEQ+2 | |
| * | ADDR[48:63] | VFDI_EV_TYPE_REQ_WORD3 | SEQ+3 | |
| * |
| * The address must be page-aligned. After receiving such a valid |
| * series of events, the PF driver will attempt to read the request |
| * and write a response to the same address. In case of an invalid |
| * sequence of events or a DMA error, there will be no response. |
| * |
| * The VF driver may request that the PF driver writes status |
| * information into its domain asynchronously. After writing the |
| * status, the PF driver will send an event of the form: |
| * |
| * 0 16 24 31 |
| * | reserved | VFDI_EV_TYPE_STATUS | SEQ | |
| * |
| * In case the VF must be reset for any reason, the PF driver will |
| * send an event of the form: |
| * |
| * 0 16 24 31 |
| * | reserved | VFDI_EV_TYPE_RESET | SEQ | |
| * |
| * It is then the responsibility of the VF driver to request |
| * reinitialisation of its queues. |
| */ |
| #define VFDI_EV_SEQ_LBN 24 |
| #define VFDI_EV_SEQ_WIDTH 8 |
| #define VFDI_EV_TYPE_LBN 16 |
| #define VFDI_EV_TYPE_WIDTH 8 |
| #define VFDI_EV_TYPE_REQ_WORD0 0 |
| #define VFDI_EV_TYPE_REQ_WORD1 1 |
| #define VFDI_EV_TYPE_REQ_WORD2 2 |
| #define VFDI_EV_TYPE_REQ_WORD3 3 |
| #define VFDI_EV_TYPE_STATUS 4 |
| #define VFDI_EV_TYPE_RESET 5 |
| #define VFDI_EV_DATA_LBN 0 |
| #define VFDI_EV_DATA_WIDTH 16 |
| |
| struct vfdi_endpoint { |
| u8 mac_addr[ETH_ALEN]; |
| __be16 tci; |
| }; |
| |
| /** |
| * enum vfdi_op - VFDI operation enumeration |
| * @VFDI_OP_RESPONSE: Indicates a response to the request. |
| * @VFDI_OP_INIT_EVQ: Initialize SRAM entries and initialize an EVQ. |
| * @VFDI_OP_INIT_RXQ: Initialize SRAM entries and initialize an RXQ. |
| * @VFDI_OP_INIT_TXQ: Initialize SRAM entries and initialize a TXQ. |
| * @VFDI_OP_FINI_ALL_QUEUES: Flush all queues, finalize all queues, then |
| * finalize the SRAM entries. |
| * @VFDI_OP_INSERT_FILTER: Insert a MAC filter targeting the given RXQ. |
| * @VFDI_OP_REMOVE_ALL_FILTERS: Remove all filters. |
| * @VFDI_OP_SET_STATUS_PAGE: Set the DMA page(s) used for status updates |
| * from PF and write the initial status. |
| * @VFDI_OP_CLEAR_STATUS_PAGE: Clear the DMA page(s) used for status |
| * updates from PF. |
| */ |
| enum vfdi_op { |
| VFDI_OP_RESPONSE = 0, |
| VFDI_OP_INIT_EVQ = 1, |
| VFDI_OP_INIT_RXQ = 2, |
| VFDI_OP_INIT_TXQ = 3, |
| VFDI_OP_FINI_ALL_QUEUES = 4, |
| VFDI_OP_INSERT_FILTER = 5, |
| VFDI_OP_REMOVE_ALL_FILTERS = 6, |
| VFDI_OP_SET_STATUS_PAGE = 7, |
| VFDI_OP_CLEAR_STATUS_PAGE = 8, |
| VFDI_OP_LIMIT, |
| }; |
| |
| /* Response codes for VFDI operations. Other values may be used in future. */ |
| #define VFDI_RC_SUCCESS 0 |
| #define VFDI_RC_ENOMEM (-12) |
| #define VFDI_RC_EINVAL (-22) |
| #define VFDI_RC_EOPNOTSUPP (-95) |
| #define VFDI_RC_ETIMEDOUT (-110) |
| |
| /** |
| * struct vfdi_req - Request from VF driver to PF driver |
| * @op: Operation code or response indicator, taken from &enum vfdi_op. |
| * @rc: Response code. Set to 0 on success or a negative error code on failure. |
| * @u.init_evq.index: Index of event queue to create. |
| * @u.init_evq.buf_count: Number of 4k buffers backing event queue. |
| * @u.init_evq.addr: Array of length %u.init_evq.buf_count containing DMA |
| * address of each page backing the event queue. |
| * @u.init_rxq.index: Index of receive queue to create. |
| * @u.init_rxq.buf_count: Number of 4k buffers backing receive queue. |
| * @u.init_rxq.evq: Instance of event queue to target receive events at. |
| * @u.init_rxq.label: Label used in receive events. |
| * @u.init_rxq.flags: Unused. |
| * @u.init_rxq.addr: Array of length %u.init_rxq.buf_count containing DMA |
| * address of each page backing the receive queue. |
| * @u.init_txq.index: Index of transmit queue to create. |
| * @u.init_txq.buf_count: Number of 4k buffers backing transmit queue. |
| * @u.init_txq.evq: Instance of event queue to target transmit completion |
| * events at. |
| * @u.init_txq.label: Label used in transmit completion events. |
| * @u.init_txq.flags: Checksum offload flags. |
| * @u.init_txq.addr: Array of length %u.init_txq.buf_count containing DMA |
| * address of each page backing the transmit queue. |
| * @u.mac_filter.rxq: Insert MAC filter at VF local address/VLAN targeting |
| * all traffic at this receive queue. |
| * @u.mac_filter.flags: MAC filter flags. |
| * @u.set_status_page.dma_addr: Base address for the &struct vfdi_status. |
| * This address must be page-aligned and the PF may write up to a |
| * whole page (allowing for extension of the structure). |
| * @u.set_status_page.peer_page_count: Number of additional pages the VF |
| * has provided into which peer addresses may be DMAd. |
| * @u.set_status_page.peer_page_addr: Array of DMA addresses of pages. |
| * If the number of peers exceeds 256, then the VF must provide |
| * additional pages in this array. The PF will then DMA up to |
| * 512 vfdi_endpoint structures into each page. These addresses |
| * must be page-aligned. |
| */ |
| struct vfdi_req { |
| u32 op; |
| u32 reserved1; |
| s32 rc; |
| u32 reserved2; |
| union { |
| struct { |
| u32 index; |
| u32 buf_count; |
| u64 addr[]; |
| } init_evq; |
| struct { |
| u32 index; |
| u32 buf_count; |
| u32 evq; |
| u32 label; |
| u32 flags; |
| #define VFDI_RXQ_FLAG_SCATTER_EN 1 |
| u32 reserved; |
| u64 addr[]; |
| } init_rxq; |
| struct { |
| u32 index; |
| u32 buf_count; |
| u32 evq; |
| u32 label; |
| u32 flags; |
| #define VFDI_TXQ_FLAG_IP_CSUM_DIS 1 |
| #define VFDI_TXQ_FLAG_TCPUDP_CSUM_DIS 2 |
| u32 reserved; |
| u64 addr[]; |
| } init_txq; |
| struct { |
| u32 rxq; |
| u32 flags; |
| #define VFDI_MAC_FILTER_FLAG_RSS 1 |
| #define VFDI_MAC_FILTER_FLAG_SCATTER 2 |
| } mac_filter; |
| struct { |
| u64 dma_addr; |
| u64 peer_page_count; |
| u64 peer_page_addr[]; |
| } set_status_page; |
| } u; |
| }; |
| |
| /** |
| * struct vfdi_status - Status provided by PF driver to VF driver |
| * @generation_start: A generation count DMA'd to VF *before* the |
| * rest of the structure. |
| * @generation_end: A generation count DMA'd to VF *after* the |
| * rest of the structure. |
| * @version: Version of this structure; currently set to 1. Later |
| * versions must either be layout-compatible or only be sent to VFs |
| * that specifically request them. |
| * @length: Total length of this structure including embedded tables |
| * @vi_scale: log2 the number of VIs available on this VF. This quantity |
| * is used by the hardware for register decoding. |
| * @max_tx_channels: The maximum number of transmit queues the VF can use. |
| * @rss_rxq_count: The number of receive queues present in the shared RSS |
| * indirection table. |
| * @peer_count: Total number of peers in the complete peer list. If larger |
| * than ARRAY_SIZE(%peers), then the VF must provide sufficient |
| * additional pages each of which is filled with vfdi_endpoint structures. |
| * @local: The MAC address and outer VLAN tag of *this* VF |
| * @peers: Table of peer addresses. The @tci fields in these structures |
| * are currently unused and must be ignored. Additional peers are |
| * written into any additional pages provided by the VF. |
| * @timer_quantum_ns: Timer quantum (nominal period between timer ticks) |
| * for interrupt moderation timers, in nanoseconds. This member is only |
| * present if @length is sufficiently large. |
| */ |
| struct vfdi_status { |
| u32 generation_start; |
| u32 generation_end; |
| u32 version; |
| u32 length; |
| u8 vi_scale; |
| u8 max_tx_channels; |
| u8 rss_rxq_count; |
| u8 reserved1; |
| u16 peer_count; |
| u16 reserved2; |
| struct vfdi_endpoint local; |
| struct vfdi_endpoint peers[256]; |
| |
| /* Members below here extend version 1 of this structure */ |
| u32 timer_quantum_ns; |
| }; |
| |
| #endif |
