| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * Copyright 2012 Sascha Hauer, Uwe Kleine-König, Steffen Trumtrar |
| * and Markus Pargmann, Pengutronix |
| */ |
| |
| /dts-v1/; |
| #include "imx27.dtsi" |
| |
| / { |
| model = "Phytec pca100"; |
| compatible = "phytec,imx27-pca100", "fsl,imx27"; |
| |
| memory@a0000000 { |
| device_type = "memory"; |
| reg = <0xa0000000 0x08000000>; /* 128MB */ |
| }; |
| }; |
| |
| &cspi1 { |
| cs-gpios = <&gpio4 28 GPIO_ACTIVE_LOW>, |
| <&gpio4 27 GPIO_ACTIVE_LOW>; |
| status = "okay"; |
| }; |
| |
| &fec { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_fec1>; |
| status = "okay"; |
| }; |
| |
| &i2c2 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_i2c2>; |
| status = "okay"; |
| |
| eeprom@52 { |
| compatible = "atmel,24c32"; |
| pagesize = <32>; |
| reg = <0x52>; |
| }; |
| }; |
| |
| &iomuxc { |
| imx27-phycard-s-som { |
| pinctrl_fec1: fec1grp { |
| fsl,pins = < |
| MX27_PAD_SD3_CMD__FEC_TXD0 0x0 |
| MX27_PAD_SD3_CLK__FEC_TXD1 0x0 |
| MX27_PAD_ATA_DATA0__FEC_TXD2 0x0 |
| MX27_PAD_ATA_DATA1__FEC_TXD3 0x0 |
| MX27_PAD_ATA_DATA2__FEC_RX_ER 0x0 |
| MX27_PAD_ATA_DATA3__FEC_RXD1 0x0 |
| MX27_PAD_ATA_DATA4__FEC_RXD2 0x0 |
| MX27_PAD_ATA_DATA5__FEC_RXD3 0x0 |
| MX27_PAD_ATA_DATA6__FEC_MDIO 0x0 |
| MX27_PAD_ATA_DATA7__FEC_MDC 0x0 |
| MX27_PAD_ATA_DATA8__FEC_CRS 0x0 |
| MX27_PAD_ATA_DATA9__FEC_TX_CLK 0x0 |
| MX27_PAD_ATA_DATA10__FEC_RXD0 0x0 |
| MX27_PAD_ATA_DATA11__FEC_RX_DV 0x0 |
| MX27_PAD_ATA_DATA12__FEC_RX_CLK 0x0 |
| MX27_PAD_ATA_DATA13__FEC_COL 0x0 |
| MX27_PAD_ATA_DATA14__FEC_TX_ER 0x0 |
| MX27_PAD_ATA_DATA15__FEC_TX_EN 0x0 |
| >; |
| }; |
| |
| pinctrl_i2c2: i2c2grp { |
| fsl,pins = < |
| MX27_PAD_I2C2_SDA__I2C2_SDA 0x0 |
| MX27_PAD_I2C2_SCL__I2C2_SCL 0x0 |
| >; |
| }; |
| |
| pinctrl_nfc: nfcgrp { |
| fsl,pins = < |
| MX27_PAD_NFRB__NFRB 0x0 |
| MX27_PAD_NFCLE__NFCLE 0x0 |
| MX27_PAD_NFWP_B__NFWP_B 0x0 |
| MX27_PAD_NFCE_B__NFCE_B 0x0 |
| MX27_PAD_NFALE__NFALE 0x0 |
| MX27_PAD_NFRE_B__NFRE_B 0x0 |
| MX27_PAD_NFWE_B__NFWE_B 0x0 |
| >; |
| }; |
| }; |
| }; |
| |
| &nfc { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_nfc>; |
| nand-bus-width = <8>; |
| nand-ecc-mode = "hw"; |
| nand-on-flash-bbt; |
| status = "okay"; |
| }; |