blob: a72d5c7215161af19348854dcc096496934bda47 [file] [log] [blame]
# SPDX-License-Identifier: (GPL-2.0-only or BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/power/reset/gpio-restart.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: GPIO controlled reset
maintainers:
- Sebastian Reichel <sre@kernel.org>
description: >
Drive a GPIO line that can be used to restart the system from a restart handler.
This binding supports level and edge triggered reset. At driver load time, the driver will
request the given gpio line and install a restart handler. If the optional properties
'open-source' is not found, the GPIO line will be driven in the inactive state. Otherwise its
not driven until the restart is initiated.
When the system is restarted, the restart handler will be invoked in priority order. The GPIO
is configured as an output, and driven active, triggering a level triggered reset condition.
This will also cause an inactive->active edge condition, triggering positive edge triggered
reset. After a delay specified by active-delay, the GPIO is set to inactive, thus causing an
active->inactive edge, triggering negative edge triggered reset. After a delay specified by
inactive-delay, the GPIO is driven active again. After a delay specified by wait-delay, the
restart handler completes allowing other restart handlers to be attempted.
properties:
compatible:
const: gpio-restart
gpios:
description: The GPIO to set high/low, see "gpios property" in
Documentation/devicetree/bindings/gpio/gpio.txt. If the pin should be low to reset the board
set it to "Active Low", otherwise set GPIO to "Active High".
open-source:
$ref: /schemas/types.yaml#/definitions/flag
description: Treat the GPIO as being open source and defer driving it to when the restart is
initiated. If this optional property is not specified, the GPIO is initialized as an output
in its inactive state.
priority:
$ref: /schemas/types.yaml#/definitions/uint32
description: |
A priority ranging from 0 to 255 (default 129) according to the following guidelines:
0: Restart handler of last resort, with limited restart capabilities.
128: Default restart handler; use if no other restart handler is expected to be available,
and/or if restart functionality is sufficient to restart the entire system.
255: Highest priority restart handler, will preempt all other restart handlers.
minimum: 0
maximum: 255
default: 129
active-delay:
$ref: /schemas/types.yaml#/definitions/uint32
description: Delay (default 100) to wait after driving gpio active [ms]
default: 100
inactive-delay:
$ref: /schemas/types.yaml#/definitions/uint32
description: Delay (default 100) to wait after driving gpio inactive [ms]
default: 100
wait-delay:
$ref: /schemas/types.yaml#/definitions/uint32
description: Delay (default 3000) to wait after completing restart sequence [ms]
default: 100
additionalProperties: false
required:
- compatible
- gpios
examples:
- |
gpio-restart {
compatible = "gpio-restart";
gpios = <&gpio 4 0>;
priority = <128>;
active-delay = <100>;
inactive-delay = <100>;
wait-delay = <3000>;
};